laserco CSH-PLGUSBPM Plug with 2 x USB & Power Monitoring User Manual
- June 5, 2024
- LASERCO
Table of Contents
laserco CSH-PLGUSBPM Plug with 2 x USB & Power Monitoring
GET THE APP
QR Codes for Downloading Apps
**REGISTER OR LOGIN TO APP
**
RECOMMENDED APP SETTINGS
CONNECTING PLUG TO APP
USING THE PLUG
PLUG SETTINGS
REMOVING PLUG
TROUBLESHOOTING
- If device is not connecting while pairing to the app please check your Wifi username and password are correct and that you are only using 2.4Ghz Wifi connections as the 5Ghz band is not supported.
- If the device is plugged in and turned on but not showing any signs of power, check any individual power switches that may be on the connected device.
- All USB plugs and the main socket are controlled by the POWER ON/OFF switch in the App. There is no way to control the USB switches separately.
- Instructions for Connecting Plug to App advised in this manual are for EZ pairing mode. If the LED light is flashing BLUE slowly then device is in AP Pairing Mode. You can press and HOLD the button again to put back into EZ pairing mode or select AP Mode in the App during the pairing process.
WARRANTY
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>