Circa Lighting PB 5152 Encircle 48″ Ring Chandelier Installation Guide

Circa Lighting PB 5152 Encircle 48″ Ring Chandelier

NOTICE

This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Slotted Screwdriver
• Measuring Tape
• Wire Cutters
• Wire Strippers

1.  Carefully remove all parts from the box. Place on a clean, soft surface.

2.  Remove mounting plate (B) from canopy (E) by removing collar ring (F).

3.  Install mounting plate (B) to the junction box and secure with mounting screws (C).

4.  Wrap the supply ground wire to the green ground screw on the mounting plate (B) and secure. (see diagram 1)
   NOTE: It is imperative that the fixture is grounded.

5.  To adjust each hanging wire loosen screws (I) on either side of wire stop (H) and adjust to desired length. Once complete re-secure screws (I) and repeat steps with the remaining wires. (see diagram 2)

6.  After fixture height is achieved shorten the wires by using a pair of wire cutters, leaving 8” of wire length to connect to driver (D).
   NOTE: Final leveling in later step will only allow for small adjustments. Make sure fixture height and fixture level are accurate before cutting wires.

7.  Remove outer housing of wire by making a neat cut all the way around, about 1” from the end. Once cut is made, remove and discard the 1” piece of housing, exposing the electrical wires.
   NOTE: Make sure not to cut too deep into housing or electrical wires could become damaged.

8.  Separate wires, and strip insulation on each 5/8″.

9.  Connect driver (D) input neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).

10.  Connect driver (D) input hot wire (black) to the supply hot wire (usually black) using wire nut (A).
    CAUTION: Do not reverse the hot and neutral connections.

11.  Connect fixture neutral wire (black) to driver (D) output wire (black) using wire nut (G).

12.  Connect fixture hot wire (red) to driver (D) output wire (red) using wire nut (G).
    CAUTION: Do not reverse the hot and neutral connections.

13.  Make sure all wire connections are tight, then carefully tuck into the junction box.

14.  Insert driver (D) into mounting plate bracket.

15.  Install canopy (E) to mounting plate (B) and secure with collar ring (F). Care Instructions: Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>