SUNCO LIGHTING 9146X LED Hybrid T8 Tubes Instruction Manual
- June 5, 2024
- Sunco Lighting
Table of Contents
LED HYBRID T8 °9146X
Instruction Manual
PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION.
Please read the instructions before you install and use the linear tube(s).
READ ALL WARNINGS AND INSTRUCTIONS PRIOR TO INSTALLING THE T8 RETROFIT LAMPS
TO ENSURE SAFETY AND PROPER OPERATION
WARNINGS – Risk of fire or electric shock. LED Retrofit Kit installation
requires knowledge of luminaire electrical systems. If not qualified, do not
attempt installation. Contact a qualified electrician in accordance with the
National Electrical Code and relevant local code.
WARNINGS – Risk of fire or electric shock. Install this kit only in the
luminaires that have the construction features and dimensions shown in the
photographs and/or drawings and where the input rating of the retrofit kit
does not exceed the input rating of the luminaire.
WARNINGS – To prevent wiring damage or abrasion, do not expose wiring to edges
of sheet metal or other sharp objects. Do not make or alter any open holes in
an enclosure of wiring or electrical components during kit installation.
This item is rated at 120-277V/ Installer must determine whether line voltage
120-277V is available at the luminaire before installation.
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE THE CORRECT BRANCH CIRCUIT
CONDUCTOR.
- Suitable for damp locations.
- This device is not intended for use with emergency exit fixtures or battery backups.
- Not for use with dimmers.
DIRECT REPLACEMENT (Plug & Go™) INSTRUCTIONS
WARNING DISCONNECT POWER BEFORE INSTALLING OR SERVICING.
- Switch off power to luminaire.
- Remove diffuser (if provided).
- Remove existing fluorescent lamp(s) from the luminaire. Note: Verify that the fluorescent tube type is listed on the LED lamp label. Check ballast compatibility list before installation, only use lamps with qualified T8 fluorescent ballast.
- Install LED lamp (one for each fluorescent lamp removed, ensure pins are firmly seated in lamp holders).
- Switch on power to luminaire and reattach diffuser (if provided).
DIRECT WIRE (Bypass) INSTRUCTIONS
DOUBLE ENDED – The below ballast wiring represents a typical configuration. The actual ballast wiring varies according to the ballasted model. It is not a requirement to change the sockets (if in good condition) to operate double- ended tubes, regardless of the socket type. Please make sure one side of the fixture is connected to Live (L) and the other side to Neutral (N).
RETROFIT LUMINAIRE WITH ONE LAMP
RETROFIT LUMINAIRE WITH TWO LAMPS
DOUBLE-ENDED WIRING INSTRUCTIONS
RETROFIT LUMINAIRE WITH THREE LAMPS
RETROFIT LUMINAIRE WITH FOUR LAMPS
PREMIUM QUALITY LIGHTING’: www.PQLighting.com
© PALL., Inc. – 2285 Ward Avenue – Simi Valley, CA 93065 –
800-323-8107
Specifications are subject to change without notice. Photos and line drawings
may not be to scale and are for general reference only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>