FIFINE M6 Wireless Lapel Microphone User Guide
- June 5, 2024
- fifine
Table of Contents
FIFINE M6 Wireless Lapel Microphone User Guide
What’s in the box
-
Microphone*1
-
Receiver*1
-
Type C cable (30cm)*1
-
Storage Bag*1
-
User Manual*1
Microphone
- Windscreen
- Indicator light Mute (red light)
- Low battery (red light blinking)
- Fully charged (green light)
- Paired (blue light stays on)
- Unpaired (blue light blinking)
- Power button
- Press: Mute/Unmute
- Press and hold for 3 seconds: ON/OFF
- Clip: 360` adjustable
- Type-C port: Charging/Monitoring
Receiver
- Indicator light
- Paired (blue light stays on)
- Unpaired (blue light blinking)
- Type-C connector
- Type-C port : Charging/Monitoring
- Pairing button (inside the hole)
Quick Start
For Android phones/Stables
-
Press and hold the power button on the microphone for 3 seconds until the indicator light blinks blue.
-
Plug the receiver into the type C port on your phone/ tablet.
-
The microphone will pair with the receiver within 5 seconds. (The blue light will stay on when connected.) If it doesn’t, please reset the mic set manually (refer to page 10-11 ).
-
After the microphone is connected, open the camera/ recording app on your phone/tablet to test the microphone. You could use these ways to listen to play back.
-
Unplug the receiver and listen to play back from the built-in speaker of phone/tablet.
-
Plug the earphone in the Type-C port on microphone/ receiver.
-
Use Bluetooth earphone.
Tips:
-
If the receiver light is off, please check if you need to enable OTG from the phone settings so that your phone will supply power for the receiver. If there’s a poor connection due to the phone case, please remove it and make sure the receiver is plugged all the way in your phone/tablet.
-
The input volume of mic and monitoring cannot be adjusted.
For iPhone/iPad
You need a genuine Apple Lighting(male) to USB (female) adapter and a
USB(male) to Type-C(female) adapter for connecting the receiver to the
iPhone/iPad. (Adapters are not included.)
Operating Range
Indoor: 65ft (maximum)
Outdoor: 50ft (maximum)
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
References
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- alza.at
- Alza | Alza.co.uk
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza.cz
- alza.de
- alza.hu
- alza.sk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>