SANIBROY Sanicompact Silence Eco+ Bathroom Toilet Instruction Manual

June 5, 2024
SANIBROY

SANIBROY Sanicompact Silence Eco+ Bathroom Toilet

INSTALLATION INSTRUCTIONS

SANIBROY-Sanicompact-Silence-Eco-Bathroom-Toilet-FIG-1SANIBROY-Sanicompact-Silence-Eco-Bathroom-Toilet-
FIG-2SANIBROY-Sanicompact-Silence-Eco-
Bathroom-Toilet-FIG-3SANIBROY-
Sanicompact-Silence-Eco-Bathroom-Toilet-FIG-4

DIMENSION

SANIBROY-Sanicompact-Silence-Eco-Bathroom-Toilet-FIG-5

OVERVIEW

SANIBROY-Sanicompact-Silence-Eco-Bathroom-Toilet-FIG-6

DESCRIPTION

This device is not designed for persons (including children) with limited physical, sensory or mental abilities, or those with minimal experience and knowledge, unless they are monitored and are given the necessary instructions for using the device, with the help of a person responsible for their safety. Monitor children and make sure they do not play with the device.

APPLICATIONS
Sanicompact ® is a specially designed WC with an integral pump/macerator to discharge WC and washbasin waste. (: depending on the model).

INSTALLATION

The fitting and working of your appliance must meet local regulations and the EN 12056-4 standard. To optimize the latest technical developments concerning soundproofing incorporated into this unit, it is important to:

  •  position the WC pan so that it is not in contact  with a partition or wall of the room
  • place the WC pan on a perfectly level surface
  • fix the discharge pipe correctly, with distances of not more than one meter between the fastenings.

CONNECTION TO THE WATER SUPPLY

Connect the water supply hose to a shut-off valve.

Caution:
The quality of the rinsing of the bowl depends on the water pressure.

WARNING:
for correct rinsing, the water pres Sure should be at least 25 PSI (1,7 bars).

Note:
In an area where water is not pure (dirty sandy), we advise you to add a filter between the shut-off valve and the toilet to prevent clogging of the solenoid valve.

CONNECTION TO THE ELECTRICAL SUPPLY

The electrical installation should be carried out by a qualified person. The unit requires a 220/240V single phase AC 50 Hz supply (UK specification). The power supply circuit of the appliance must be earthed (Class ) and protected by a GFC high sensitivity (30mA). Warning: Ensure the electricity is turned OFF at the main switchboard before wiring to the connector. All wiring must conform to BS7671, 1992 requirements for electrical installations. Do not connect the unit to a conventional plug and socket. It must be wired into a fused, unswitched, fixed wiring connector fitted with a 5 amp fuse. The wires in the mains lead are colored in accordance with the following code:

  • Brown-Live
  • Blue – Neutral
  • Green/Yellow- Earth

The connection must be used exclusively to power the device. All work on cable, pressure chamber and motor should only be carried out by a qualified Saniflo servicing agent, as special tools are required. Please do not cut/shorten the electrical supply cable which can make it very difficult to remove in the event of a service requirement. Open the water tap to rinse well. Start the normal flush by pressing the dark grey button. Put a few sheets of toilet paper down in the bowl and flush again.

PROGRAMMING

SANICOMPACT® Eco is controlled by an electronic programmer. The duration of operation varies according to the cycle chosen.

  • Eco flush (light grey button)
  • Normal flush (dark grey button)

You can lengthen the rinse if the default flush is not enough. (Low supply pressure)

To re-program:

  • Press the two grey buttons at the same time for 5 seconds. (model without wash basin option)
  • Press the dark grey button for 5 seconds (model with wash basin option)
  • The motor runs for 2 seconds, this means you have entered programming mode.
  • Each time you press the dark grey button you increase the length of the flush by 1 second: each time you press it will be validated by the motor running for a short period.
  • Each time you press the light grey button you decrease the length of the flush by 1 second: each time you press it will be validated by the motor running for a short period.

To exit programming mode:

  • Do nothing for several seconds
  • Note:
    The duration of operation varies according to the cycle chosen.

Operating wash basin:
Please make sure that the wash basin tap draining into the sand compact is properly shut off after usage and not dripping.

MAINTENANCE

WARNING !!
In the event of prolonged absence, it is essential to turn off the water supply to protect the installation against sub-zero temperatures.

CARE OF YOUR UNIT

In order to remove the scale and clean the mace rator and the bowl, use the SANIFLO Cleanser/Descalent.

  • Disconnect the macerator power supply,
  • Pour an amount of cleanser into the pan
  • Leave it to stand for 1 or 2 hours,
  • Re-connect the macerator power supply,
  • Rinse by operating the flushing system twice

Carry out the operation once every 3 months on average, but the frequency may need to be changed depending on the hardness of the water.

FAULT FINDING/REMEDIES

IN ALL CASES, YOU MUST DISCONNECT THE MACERATOR FROM THE POWER SUPPLY SANIBROY-Sanicompact-Silence-Eco-Bathroom-Toilet-FIG-7

GUARANTEE

2-year guarantee as from its date of purchase subject to correct installation and correct use.

WARNING:
Only the disposal of toilet paper, fecal matter, and wastewater will be under guarantee. Any damage due to foreign bodies such as cotton, condoms, sanitary towels, wet wipes, food, hair, metal, wood, or plastic objects, will not be under guarantee. Solvents, acids, and other chemicals can also cause damage to the unit and will invalidate the guarantee.

SANIFLO Ltd.,
Howard House, The Runway South Ruislip Middx., HA4 6SE
Tel. +44 208 842 0033/4040
Fax +44 208 842 1671

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals