CDA CCA52 50cm Canopy Extractor Installation Guide
- June 5, 2024
- CDA
Table of Contents
CDA CCA52 50cm Canopy Extractor Installation Guide
Important
The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment.
This appliance is not designed to be used by people (including children) with
reduced physical, sensorial or mental capacity, or who lack experience or
knowledge about it, unless they have had supervision or instructions on how to
use the appliance by someone who is responsible for their safety.
Under no circumstances should any external covers be removed for servicing or
maintenance except by suitably qualified personnel.
Appliance information:
Please enter the details on the appliance rating plate below for reference, to
assist CDA Customer Care in the event of a fault with your appliance and to
register your appliance for guarantee purposes.
Appliance Model
Serial Number
Declarations of Conformity:
This appliance has been manufactured to comply with all EU & UK statutory requirements and complies with all applicable legislation and the following European Directives:
- The Low Voltage Directive 2014/35/EU
- Electromagnetic Compatibility Directive 2014/30/EU
The product has been marked with the UKCA and CE symbols.
This appliance is marked according to the European directive
2004/104/EC on Waste Electrical and Electronic equipment (WEEE).
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19/EU.
At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer providing appliance recycling services.
Disposing of a household appliance separately avoids possible negative consequences for the environment and health. It also enables the constituent materials to be recovered, saving both energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.
Please note:
-
Under no circumstances should the extractor be connected to any gas ventilation system, flue system or hot air ducting system.
-
Do not vent the extractor into an attic or loft space.
-
Only house the extractor in rooms with adequate ventilation.
Remember that the extractor is powerful and whatever air is extracted needs to be replaced. -
Do not tile the extractor in. It should be removable for service or maintenance.
-
Do not use silicone sealant to secure the hood to the wall.
-
You must be able to isolate the extractor from the mains electrical supply after installation.
-
This extractor has been designed to be used in a room with a volume of less than 36m .
-
Steam cleaners must not be used when cleaning this appliance.
-
The performance of your extractor will vary depending on a number of factors. These include: type of extraction, length of ducting, room volume, ventilation available and cleanliness of the filters.
Using your Extractor
For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking.
Control Panel
- A – Power off button
- B – Speed level buttons
- C – Light button
To switch the extractor light on or off
- Press button “C”.
To switch on the extractor or to change the speed at any time when the extractor is running
- Press the relevant “B” button for the first, second or third speed level as required.
To switch the extractor off
- Press the “A” button.
Care and Maintenance
IMPORTANT：DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.
Cleaning
You should use a non-abrasive cleaner. Any abrasive cleaner (including Cif)
will scratch the surface and could erase the control panel markings.
You can clean you extractor effectively by simply using a dilute solution of water and mild detergent and drying to a shine with a clean cloth.
Cleaning the grease filter
The grease filter should be kept clean to minimize the risk of fire.
At least once a month the grease filters should be removed and cleaned with warm soapy water. You can also wash the grease filters in a dishwasher, ensuring that the filters are put in an upright position to prevent damage from other items in the dishwasher. After rinsing and drying, replace the filter.
To remove the grease filter, push in the button on the handle and then pull down on the filter at the front. When you have released it at the front, then you can pull out the filter. To replace the grease filter, repeat the steps in reverse.
Please note:
Cleaning the grease filter in the dishwasher may lead to discolouration.
This is normal and does not constitute a fault with the appliance.
Please note:
The extractor must not be used without the grease filter in place.
Charcoal filter
In re-circulating mode, air is vented back into the kitchen through the opening in the cooker hood.
This method is advised if you are not using your hob intensively.
Re-circulated air requires the use of charcoal filters to remove odours.
To ensure the best performance from your cooker hood, the charcoal filter should be replaced every 3-6 months, dependent on use.
Note: This charcoal filter is non-washable and must be replaced as required.
To attach a new charcoal filrer, follow the steps below:
- Remove the grease filter (fig.3-I).
- Place the charcoal filter on the centre of the motor support. Once firmly located, turn the charcoal filter clockwise 90 degrees until the filter locks into position(fig.3-II).
- Replace the grease filter(fig.3-III)
The LED lights
In case of malfunction of the illumination system contact the technical service.
Replaceable (LED only) light source by a professional
Electrical Information
Mains electrical voltage: 230 – 240Vac
Total rated power consumption:
44W
Troubleshooting
Please note:
Your extractor is equipped with a motor protection device that will switch off
the motor to prevent damage from overheating. This may happen during cooking
when most or all of the zones/burners are being used simultaneously, or if
your extractor is installed incorrectly, lower than the recommended height.
This is normal, and the extractor will work again once the motor has cooled sufficiently.
If your extractor is not working:
- Check that the mains supply has not been switched off.
- Check that the fuse in the spur has not blown.
Contact CDA Customer Care
- A: Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY
- T: 01949 862 012
- F: 01949 862 003
- E: customer.care@cda.eu
- W: www.cda.eu
Mains electrical connection
Warning! This appliance must be earthed.
This appliance must be connected by a competent person, using fixed wiring via
a double pole switched fused spur outlet, protected by a 3A fuse.
We recommend that the appliance is connected by a qualified electrician, who
is a member of the N.I.C.E.I.C. and who will comply with the I.E.T. and local
regulations.
The wires in the mains lead are coloured in accordance with the following
code:
GREEN AND YELLOW = EARTH
BLUE = NEUTRAL
BROWN = LIVE
As the colours of the wires in the mains lead for the appliance may not correspond with the coloured markings identifying the terminals in your spur box, proceed as follows:
- The wire which is coloured green and yellow must be connected to the terminal marked E (Earth) or coloured green
- The wire which is coloured blue must be connected to the terminal marked N (Neutral) or coloured black
- The wire which is coloured brown must be connected to the terminal marked L (Live) or coloured red
GUARANTEE
You new product is guaranteed against defects in materials and/or workmanship. Any parts found to be defective will be repaired or replaced at our discretion. All repairs must be carried out by an authorised service engineer.
THIS GUARANTEE IS VALID PROVIDING THAT :
- The appliance has been installed by a suitably qualified person
- Installation has been carried out in accordance with instructions and current legislation
- Proof of purchase can be produced
- The appliance has been used for domestic purposes only
- The appliance has not been tampered with or repair attempted or modified by any unauthorised person
THIS GUARANTEE DOES NOT COVER :
- Damage by misuse, neglect or transit
- Use of parts that have not been recommended
- Routine maintenance, general wear & tear and installation faults
- Rubber seals, removable glass and/or plastic parts, fuses or light bulbs which all need replacing periodically
- Second-hand or reconditioned appliances
- Appliances used for commercial or professional purposes
This guarantee does not in any way affect your statutory legal rights.
Installation
When the extractor is to be installed above an electric hob, the minimum distance between the hob and extractor must exceed 600mm for ceramic and solid plate hobs and 550mm for induction Hobs.
When the extractor is to be installed above a gas hob, the minimum distance between the hob and extractor must exceed 650mm.
If the instructions provided with your gas hob state that the required distance between the hob and the extractor must be greater than 650mm, then that is the distance which should be observed. This is a legal requirement and may lead to your hob being disconnected from the gas supply and the installation reported to RIDDOR (the height should be measured from the top of the burners).
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH THE GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND EXTRACTOR MUST BE AT LEAST 650mm.
The width of any hob must not be greater than the width of the extractor installed above it.
Energy Efficiency Information
Attribute| Symbol| Value| Units
Model Identification| | CCA52| CCA72|
Annual Energy Consumption| AECHOOd| 26.5| 26.5| kWh
Time increase factor| f| 1.7| 1.7|
Fluid Dynamic Efficiency| FDEHOOd| 9.4| 9.4|
Energy Efficiency Index| EEIHOOd| 69.0| 69.0|
Measured airflow at Best Efficiency Point| QBEP| 94.7| 94.7| m3/h
Measured Pressure at Best Efficiency Point| PBEP| 136| 136| Pa
Maximum airflow| AMAX| 206.4| 206.4| m3/h
Measured electric power at Best Efficiency Point| WBEP| 38.0| 38.0| W
Nominal lighting power| WL| 4.0| 4.0| W
Average illumination of the lighting system on the cooking surface| Em!cile|
309| 309| Lux
Measured power consumption in standby| Ps| N/A| N/A| W
Measured power consumption off mode| Po| 0.0| 0.0| W
Sound power level| 64| 63| 63| dBA
Grease Filter Efficiency| GFEHOOd| 49.1 (F)| 49.1 (F)| %
Lamp efficiency| LEHOOd| 77 (A)| 77 (A)| %
E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the right to change specifications without prior notice.
For service or queries relating to your product please contact:
The Customer Care Department on 01949 862 012 or email
customer.care@cda.eu
For more information please contact:
The Sales Department on 01949 862 010 or email
sales@cda.eu
Customer Care Department. The CDA Group Ltd, Harby Road, Langar,
Nottinghamshire, NG13 9HY
T: 01949 862 012
F: 01949 862 003
E: customer.care@cda.eu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>