ENDON 99774 Dedicated Reader LED Floor Spot Light Instruction Manual
- June 13, 2024
- ENDON
Table of Contents
Installation and Safety Instructions
LED Floor Light
99774 Dedicated Reader
Safety Warnings
These instructions are for your safety. Please read through them thoroughly
before use and retain them for future reference. If you are in any doubt about
installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply. It is
for indoor use only, and not suitable for a bathroom location.
This product is Class III (low voltage) and uses a plug-in transformer. Under
no circumstances must this be replaced by a standard 13amp UK type plug. This
will cause a safety hazard.
Do not attempt to plug in or use this product until it has been fully
assembled. Disconnect from mains during assembly or maintenance. this product
must be used on a stable, flat surface.
Under no circumstances must this lamp be covered with any material as this
could pose a safety hazard.
This product is not a toy and not suitable for persons under 14 years of age.
This product may contain delicate parts – be careful during handling and
maintenance to avoid breakage.
Never put anything on the product or hang anything on any part of this
product.
If the external flexible cable or cord of this luminaire is damaged, it must
only be replaced by a qualified electrician to avoid any electrical hazards.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.
Care and maintenance
Allow 10 minutes to cool before adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Troubleshooting
When the lamp does not light after installation:
- Please connect the driver to the product and plug in the LED driver.
- Please operate the push button of the 3 stage dimmer switch to turn on.
- Please check the relevant fuse in your fuse box.
If you have any doubt about installation/use of this product, consult a qualified electrician.
Assembly Instructions
Gently pull any excess cable through from under the base and then out through
the side of the base. Turn the completed assembly anticlockwise approximately
6 times (Turning the tubes anticlockwise first ensures that the cable will
straighten when the tubes are fully assembled). Screw the assembly in a
clockwise direction on to the base. 
https://qrco.de/bbiq6g
Scan QR code for multi-language UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>