athom PG03 Power Monitoring Plug User Manual
- June 5, 2024
- athom
Table of Contents
athom PG03 Power Monitoring Plug User Manual
Inductions
Step 1: Power on the device and use your computer or phone search the
WiFi until find athom_xxxx and click to connect, wait several seconds until
configuation page pop up.
Step 2: Input your 2.4G WiFi router SSID and password, then click save.
Step 3: then go to your Home Assistant It will shows new devices
discovered, press config to add it successfully.
Step 4: After config successfully , now you can monitoring and control the device with Home Assitant.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Notice : for more information
http://www.athom.tech
https://github.com/athom-tech/athom-configs
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>