athom LS8P LED Strip Light Controller User Manual
- June 9, 2024
- athom
Table of Contents
WLED User Manual
Wire Diagram
To reset the strip light controller, press and hold the key for more than 7
seconds.
To reset an LED bulb, turn it off and wait for 2 seconds. Then turn it on for
2 seconds, and repeat this process four times until the WLED xxxx hotspot is
detected..
Please be careful not to burn out your bulb by forcing all channels to be on
using color or RGB and white.
Step 1: Turn on the device and use your computer or phone to search for the WiFi network named WLED_xxxx. Click to connect, and wait a few seconds for the configuration page to appear.
Step 2: Select WIFI SETTINGS, then enter your 2.4G WiFi router’s SSID and password. Finally, click SAVE to save the settings.
Step 3: Open your WLED app and click the + symbol to discover a new device.
Step 4: Configure your strip light to your liking.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
The device must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions : (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the
FCC’s RF exposure guidelines, place the product at least 20cm from nearby
persons.
www.athom.tech
support@athom.tech
For more informationhttps://kno.wled.ge
https://www.athom.tech
Documents / Resources
|
athom LS8P LED Strip Light
Controller
[pdf] User Manual
LS8P, 2A7ZI-LS8P, 2A7ZILS8P, LS8P LED Strip Light Controller, LED Strip Light
Controller, Strip Light Controller, Light Controller, Controller
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>