La Crosse 435-3239 15.5-Inch Indoor Outdoor Lighted Leaves Wall Clock User Manual
- June 5, 2024
- La Crosse
Table of Contents
La Crosse 435-3239 15.5-Inch Indoor Outdoor Lighted Leaves Wall Clock
WARRANTY & SUPPORT
This product is warranted to be free from defects in material and workmanship
under normal use and service for a period of two years from the date of sale
to the customer. Warranty will not apply to defects resulting from abuse,
accidents, or misuse. If a defect that is covered by this warranty arises
during the warranty period, promptly return the clock (postage prepaid) with
proof of purchase showing the date the clock was purchased to the following
address and such defects will be repaired, or the products will be replaced at
La Crosse Clock Company option without charge.
La Crosse Clock Company, Warranty Department,
2830 South 26th Street., La Crosse, WI 54601
For Online support visit:
www.lacrossetechnology.com/support
CARE + MAINTENANCE
Battery replacement instruction:
When batteries of different brand or type are used together, or new and old
batteries are used together, some batteries may be over-discharged due to a
difference of voltage or capacity. This can result in venting, leakage, and
rupture and may cause personal injury.
- Always purchase the correct size and grade of battery suitable for the intended use.
- Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of different types.
- Clean the battery contacts and those of the device prior to battery installation.
- Ensure the batteries are installed correctly with regard to polarity (+ and -).
- Remove batteries from product during periods of non-use. Battery leakage can cause corrosion and damage to this product.
- Remove used batteries promptly.
- For recycling and disposal of batteries, and to protect the environment please check the internet or your local phone directory for local recycling centers and / or follow local government regulations.
CA WARNING:
This product can expose you to chemicals including acrylonitrile, butadiene,
and styrene, which are known to the State of California to cause cancer and
birth defects or other reproductive harm.
For more information, go to:
POWER UP CLOCK
- Remove Round Battery Cover to access the clock movement and battery compartment.
- Insert 1 AA battery into the movement in the center of the clock.
- Spin the time set wheel to set the time.
Note: The quartz movement will keep the clock running accurately. If the
clock does not operate, or steadily loses time, replace the battery.
Learn more from our video: bit.ly/wallclock_setup
Thermometer/Hygrometer
- Your thermometer and hygrometer (sensors) have been pre-calibrated and should not need adjustment.
- Before manually adjusting your sensors, allow the clock to sit for at least 2 hours in the same location.
- To manually adjust your sensors, gently turn the temperature or humidity sensor adjustment on the back of the clock until desired setting is reached.
POWER UP LIGHTED DIAL
Remove the Lighted Dial Battery Covers and insert 4 D batteries into the
Battery Compartments.
IMPORTANT: Be sure all batteries are of the same voltage.
Light Sensor Switch
Set to ON to activate the Lighted Dial in dark conditions. Set to OFF to
deactivate this function all together and conserve batteries.
The Light Sensor is located on the front of the clock between the six and
seven. The light timer will reset once the clock is exposed to light. When it
gets dark, the Lighted Dial will stay on for 6 hours and then automatically
shut off.
SPECIFICATIONS
- Battery Requirements: 1 AA (IEC LR6) required in movement. 4 D (IEC LR20) for Lighted Dial. Batteries not included
- Clock Battery Life: 1 Battery – 1 year,
- Temperature Range: -20ºF to 120ºF (-28.8ºC to 48.8ºC)
- Humidity Range: 10% to 90% RH
- Dimensions: 15.55” L x 3.03” W x 15.55” H (39.5 cm L x 7.7 cm W x 39.5 cm H)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>