RECYKO CHARGE 10 S491 10 Ultra-Fast Charger Instruction Manual
- June 5, 2024
- RECYKO CHARGE 10
Table of Contents
RECYKO CHARGE 10 S491 10 Ultra-Fast Charger
Unpacking and checking
You should find the following items in the packaging*. Please make sure they are undamaged and in good working order.
- Charge 10 Ultra-Fast Charger (AC) S491 4-slot NiMH
- Power cord
For exact items in the pack, please refer to “In the box” section of the packaging. The specifications of the wall charger may vary based on the country version purchased.
Approximate Charging Time
DC 4 x 1.6V 0.3-10A
| Range (Size)| Capacity (mAh)| Quantity| Charging time
---|---|---|---|---
Ultra-fast charging mode| Eco charging mode
Charge 10 battery (AA)| 1,700| | 10mins**| 200min
Recyko / Recyko Pro battery (AA)| 1,300-2,600| 1-4pcs| 15-35mins| 160-320min
Recyko / Recyko Pro battery (AAA)| 650-950| | 28-45mins| 160-230min
Approximate charging time is based on the same battery size and capacity at ambient temperature (20℃). Individual battery charging completion times may have a few minutes difference. Charges 1-4pcs of Recyko Charge 10 AA 1700mAh to 90%+ of capacity at 20℃ using Ultra-fast charging mode in 10mins.
LED Indication
| Conditions | LED indicator |
|---|
Ultra-fast charging mode
Charging in progress| Blue (Flashing)
Charging completed| Blue
Over-temperature warning#| Blue and red (Flashing alternatively)
Eco charging
Charging in progress| Green (Flashing)
Charging completed| Green
Over-temperature warning#| Green and red (Flashing alternatively)
Detections
Bad or single-use batteries| Red (Rapid flashing)
System Warning| Red, Blue, and Green
To avoid this condition, the operation temperature should be on or under 33°C. If the condition persists, the batteries are needed to charge in Eco charging mode or replace new batteries.
Features
- User-selectable Ultra-fast and Eco charging modes
- Individual charging of 1–4 pcs of AA / AAA NiMH batteries
- Charging Termination: negative delta V, safety timer & temperature cut-off protections
- Tri-color LED indication (Blue, Green & Red) for charging conditions and system statuses
- Trickle charge
- Built-in, integrated AC power supply
- High efficiency, low noise cross-flow cooling fan
Read the instruction manual thoroughly before use. Keep the manual for future reference.
Charging Instructions
- Connect the AC power cord to the battery charger (Fig. 1a).
- Plug the other end of the AC power cord into a wall socket (Fig. 1b).
- Slide up at the edge of the battery cover (Fig. 2a). And insert 1-4pcs NiMH batteries into the battery charger according to the battery polarity (Fig. 2b). The Blue and Green LEDs will flash alternatively.
- Slide to close the battery door and press the button to select the Ultra-fast or Eco charging modes within 5 seconds (Fig. 3).
- Ultra-fast charging mode: Used for maximum charging speed. (Approx. charging time to charge up 90%+ capacity of Recyko Charge 10 AA 1700mAh batteries in 20°C operation temperature: 10 minutes)
- Eco charging mode: Provide a comfortable charging condition for the battery which helps to prolong the battery life cycle.
- Charging will commence and the LED indicators will show the charging status of the batteries.
- In Ultra-fast charging mode, the Blue LEDs will be flashing when the batteries are charging. And they stay solid when the batteries are fully charged.
- In Eco charging mode, the Green LEDs will be flashing when the batteries are charging. And they stay solid when the batteries are fully charged.
- For bad or single-use batteries, the LEDs will flash Red rapidly. Remove these batteries from the charger.
- For over-temperature warning, Blue-Red or Green-Red LEDs will be flashing according to Ultra-fast charging mode or Eco charging mode. Recommend to charge the batteries at +20 ~ +25°C
- For system warning, Red, Blue, and Green LEDs will flash alternatively. Please disconnect and resume the power to restore operation.
- Once batteries are fully charged and LEDs stay solid, slide to open the battery cover to remove the batteries and disconnect the battery charger from the power supply.
For best performance, always use Recyko Charge 10 AA 1700mAh batteries.
Usage tips
- It is normal for batteries to become hot during charging and they will gradually cool down to room temperature after being fully charged.
- Remove batteries from the electrical device if the device is not going to be used for a long time.
- Charger storage temperature: -20 ~ +35°C.
- Charger operation temperature: 0 ~ +33°C.
- Charging time is based on the same battery size and capacity at an ambient temperature of +20°C.
- The sliding battery cover is to protect the user from accessing the batteries at high temperatures during charging. Opening the sliding battery cover will stop the charging immediately.
- If the over-temperature warning persists, move the charger to a lower temperature environment of +20 ~ +25°C, suggest replacing the battery(ies) or using a new Recyko Charge 10 battery(ies) instead.
- When AA and AAA batteries are mixed for charging, the charger will charge the AA battery (ies) and then be followed by the AAA battery(ies). The charging time may be longer than the charging timetable mentioned.
After completed the charging, the fan will continue to cool down the battery for a few minutes. Suggest the user remove the batteries after the fan stops.
Safety information
- This charger is designed to charge NiMH batteries only. Do not use non-rechargeable, LiFePO4, NiCd, or Li-ion batteries. Charging other batteries may lead to an explosion, battery rupture or leakage, personal injury, or property damage.
- This charger is designed for indoor use only. Do not expose the charger to rain, snow, or direct sunlight.
- Do not use the charger in humid conditions.
- Make sure the charger is used between 0 ~ +33°C.
- Do not use the charger if the plug is damaged.
- Do not use the charger after it has been dropped or damaged.
- Do not open/disassemble the charger.
- In case a battery sleeve is damaged, do not use it in the charger.
- Never remove the outer sleeve from batteries.
- Please use the charger in a well-ventilated place and ensure there are no other items covering the charger to avoid overheating. Do not stack-up multiple chargers while charging.
- This charger is maintenance-free but should be wiped clean regularly with a dry and soft cloth. Do not use abrasives or solvents. Unplug the charger before cleaning.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>