Franklin Electric 996781 Simplex Grinder Pump Control Panel and Alarm Instruction Manual
- June 5, 2024
- Franklin Electric
Table of Contents
SIMPLEX GRINDER PUMP CONTROL PANEL AND ALARM
Instruction Manual
APPLICATIONS
- Simplex Grinder Pump Control Panels and Alarms are designed exclusively for use with IGP Grinder Series pumps in applications such as lift pump chambers and sewage ejector basins
FEATURES
- Controls the pump and warns of high liquid levels
- Color-coded terminal strip for ease of installation
- Corrosion-resistant NEMA 4X fiberglass, waterproof enclosure with padlock provision
- HOA switch allows for “Hand” (manual), “Off” or “Automatic” operation
- Three floats (sold separately) control on, off, and alarm functions
- The alarm ON/OFF switch controls the power to audible and visual alarm signal device
- Contains start and run capacitors and start relay necessary for proper motor operation and third-party approval
- CULus listed
SERIES SPECIFICATIONS
Item No.| Model No.| Volts| Hz| Phase| FLA|
Weight (lbs)
---|---|---|---|---|---|---
515354| A-SF230CBG-215| 208/230| 60| 1| 16| 15
515361| 1052443| 208/230| 60| 1| 22| 15
ENGINEERING DATA
TYPICAL INSTALLATION
INSTALLATION INSTRUCTIONS
WARNING: Turn off the power source before installing or adjusting this device. Failure to turn off power could result in serious or fatal electric shock.
-
Determine the mounting location for the control panel. Liquid-tight connectors should be used on all cables entering the panel. Conduit connectors, if used, must be sealed.
-
Check local codes, the schematic, and the installation/operation manual for power circuit requirements. On the control panel, determine the “power in” location
(from the building power supply). CAUTION: BE SURE THE POWER SUPPLY VOLTAGE AND PHASE ARE THE SAME AS THE PUMP MOTORS BEING INSTALLED. -
Determine the location on the control panel for the pump power cables and float switch cables. Drill holes to fit the type of cable fittings to be used.
-
Attach floats as shown in the Typical Installation drawing and instruction manual.
-
Following step-by-step instructions and wiring diagram included with the panel, complete connections of all cables.
-
Follow the “Manual Testing” procedure in the instruction manual.
NOTE: Franklin Electric cannot be responsible for damages caused by
faulty or negligent installation of the control. We recommend that you engage
the services of a competent plumber, electrician, or qualified service person
to install this product in accordance with national and local electrical
codes.
ACCESSORIES: Some installations may require a moisture-free junction box to
house electrical connections. These are available with liquid-tight
connectors.
The liquid-tight connectors are also available separately.
9255 Coverdale Road, Fort Wayne, IN 46809
Tel: 1.866.271.2859 Fax: 1.866.271.2709
franklinengineered.com
996781 04-20
Documents / Resources
|
Franklin Electric 996781 Simplex Grinder Pump Control Panel and
Alarm
[pdf] Instruction Manual
996781, Simplex Grinder Pump Control Panel and Alarm, 996781 Simplex Grinder
Pump Control Panel and Alarm
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>