catit 43715 Pixi Drinking Fountain User Manual

June 3, 2024
catit

catit logocatit logo 1

DRINKING FOUNTAIN
USER MANUAL

catit 43715 Pixi Drinking Fountain

MORE INFORMATION

43715 Pixi Drinking Fountain

SAFETY TIPS
INSTRUCTIONS PERTAIN- ING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTION

WARNING: To guard against injury, basic safety precautions should be observed, including the following:

  1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS and all the important notices on the appliance before using the pump. Failure to do so may result in damage to this appliance.

  2. DANGER – To avoid possible electrical shock, special care should be taken since water is employed in the use of this product. For each of the following situations, do not attempt repairs yourself; return the pump to an authorized service facility for service if it is still under warranty or discard the appliance.
    If the pump shows any sign of abnormal water leakage, disconnect the power supply cord and remove the pump from the water.
    B Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.
    C Do not operate the appliance if it has a damaged electrical cord or plug, if it is malfunctioning or if it is dropped or damaged in any manner. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard. Never cut the cord.
    D  The electrical outlet should always be above the level of the appliance. If the plug or outlet does get wet, DO NOT unplug the electrical cord. Disconnect the fuse or circuit breaker that supplies power to the appliance, then unplug and examine for the presence of water in the outlet.

  3. This appliance is not intended for use by persons (including children) with significantly impaired physical or mental capabilities unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should always be supervised to ensure that they do not play with the appliance.

  4. To avoid injury, do not contact moving or hot parts.

  5. CAUTION Always unplug or disconnect the appliance from the outlet before putting on or taking off parts and while the equipment is being installed, maintained, or handled. When inserting or removing the pump from the water, pull out the main electrical plug. Never yank the cord to pull the plug from the outlet. Grasp the plug and pull to disconnect. Always unplug an appliance from an outlet when not in use. Never lift the pump by the cord.

  6. CAUTION: THIS IS A PET DRINKING FOUNTAIN PUMP. This pump has been evaluated for use with freshwater only. Do not use this pump for other than its intended use (i.e. don’t use it in swimming pools, bathtubs, etc.). The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
    • Do not use the pump in swimming pools or other situations where people are immersed.
    • This pump is suitable for use in water temperatures up to 35ºC.
    •  Do not use this pump with inflammable liquids.

  7. Do not install or store the appliance where it will be exposed to temperatures below freezing. Shelter the pump from direct sunlight.

  8. Ensure that the appliance is placed on a flat, even surface. Monitor the appliance regularly. Do not leave appliances unattended for extended periods. Do not allow the pump to run dry. The pump must be immersed in water completely. This pump must never operate outside of water.

  9. If an extension cord is necessary, ensure the connection is watertight and dustproof. A cord with a proper rating should be used. A cord rated for fewer amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.

  10. Do not use this unit outdoors. This unit is for indoor use only.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Only the faithful observation of this installation, electrical, and maintenance guidelines will ensure the safe and efficient use of this drinking fountain.

RECYCLING: This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. Check with your local Environmental Agency for possible disposal instructions or take it to an official council-registered refuse collection point. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of hazardous substances.

CONTENTS

catit 43715 Pixi Drinking Fountain CONTENTS

  1. Spout Accessory

  2. Fountain top

  3. Filter tray
    3a. Anti-overflow opening
    3b. Silicone tube

  4. Filter cartridge

  5. Pump

  6. Fountain reservoir

  7. Adapter

All pictures shown in the manual are for illustration purposes only. Actual products may vary due to product enhancement.

PARTS

A Pump cover

B Impeller Cap
C Impeller
D Pump Housingcatit 43715 Pixi Drinking Fountain PARTSUSAGE

 Cats can be picky drinkers. Some prefer large water surfaces over vertical streams and vice-versa. The Catit ® PIXI TM Fountain provides your cat with a continuous indoor source of fresh, clean water and allows different water flow settings to encourage your pet to drink more. Drinking more water helps ensure proper kidney function, helping to prevent crystal formation that can lead to urinary diseases.
The anti-overflow openings in the filter tray will prevent water from rising in case the filter cartridge gets clogged, though the filter should always be replaced if it is visibly dirty,  damaged, or clogged.
The pump is equipped with a sensor that detects when the water level inside the reservoir is too low. At that point, the fountain will shut down automatically, to prevent the pump from running dry. Once the water reservoir is refilled, the fountain will start running again. For PIXI TM Fountain

43720 with stainless steel top: To prevent limescale  deposits and to keep

the stainless steel top in good shape, it’s recommended to clean the stainless steel top in the dishwasher regularly (e.g. once or twice a week, at first signs of
limescale deposits)

INSTALLATION

Take the unit out of the packaging. Remove the fountain top and filter tray. Insert the USB cable into the cable gutter in the water reservoir and pull the cable through. Position the pump to the side.

Clean the fountain before use to remove any dirt or debris. Wash the complete unit (excluding the filter) with a sponge. Do not use abrasive cleansers or materials on any part of the unit. Rinse thoroughly.

catit 43715 Pixi Drinking Fountain INSTALLATION 2

Attach the pump to the fountain top by pushing it onto the silicone tube, so that the pump LEDs are facing left. Make sure that the pump is level.

Lower the filter tray down onto the reservoir and press the USB cable down into the groove so it is secure.

Take the filter cartridge out of the polybag. Rinse the filter to remove excess dust and soak it completely.

Insert the filter cartridge into the filter tray with pockets facing down. Press down on the cotton part of the filter so it gets tucked underneath the plastic in the center.

Lower the fountain top onto the reservoir, with the indentation facing forward.  Fill the fountain with water. The water level can be seen through the transparent window in front of the reservoir. Do not overfill the fountain.

(Optional) Insert the spout accessory into the opening on the fountain top to create a water spout for your cat to drink from. Point the spout in the preferred direction. Press down firmly to attach, and pull up to remove.

Attach the power cord to the USB adapter, and plug it into the wall socket. Secure the excess power cord with a tie wrap and place it behind the fountain to avoid pet chewing and entanglement.

LED INDICATORS

Pump LEDs Steady white Fountain ON
White OFF Fountain OFF / Water level low / Reservoir empty
Blinking red Low water level
Steady red Reservoir empty

TROUBLESHOOTING

Problem Possible reason
No water is coming out of the fountain Unplug the fountain and plug it back

into the electrical socket. If the problem persists, the pump needs to be cleaned (see maintenance section).
The pump LED is blinking red, and/or the pump is making noise and no  water is coming out of the fountain| Please refill the reservoir and make sure the pump is level and attached correctly to the top (see instructions).
The pump LED is blinking red/white alternatively, and water isn’t coming out steadily| The fountain is running out of water, please refill it.

MAINTENANCE

WARNING:

Always unplug or disconnect the pump from the electrical supply with dry hands before putting on or taking off parts and whenever the pump is being installed, maintained, or handled. Wash and rinse the fountain with a soft sponge and a non-abrasive cleanser. Rinse thoroughly, ensuring no soapy residue. Remove the filter from the base and rinse. Do not wash the filter with soap. If the filter contains excess debris or other foreign matter, replace it (replacement filters are sold separately). The filter should be replaced every 3-4 weeks or when there are visible signs that the filter is saturated with foreign matter (debris, food, hair, etc.) or if the water flow is impeded. More frequent changes may be necessary due to indoor environmental and water conditions, as well as multiple pet use.
Should the pump appear dirty, open the pump and remove the impeller cap and impeller (see illustrations on page 33). Remove any debris from the impeller and clean the impeller well with running water. Handle the impeller with care. If the pump makes noise, clean the pump as described above and top up the water level in the fountain reservoir so the pump is fully submerged. DO NOT ALLOW THE PUMP TO RUN DRY.

Open the pump, and remove the impeller cap and impeller.

Rinse each part with water, removing any hairs or debris from the impeller and pump housing, before carefully reassembling.

WARRANTY

Your Catit ® PIXI TM Fountain is guaranteed for defective parts and workmanship for a period of 2 years from the date of purchase. This guarantee is valid with proof of purchase only. The guarantee is limited to repair or replacement only and does not cover consequential loss, loss, or damage to livestock and personal property, or damage to animate or inanimate objects, irrespective of the cause thereof. This guarantee is valid only under normal operating conditions for which the unit is intended. It excludes any damage caused by unreasonable use, negligence, improper installation, tampering, abuse, or commercial use. The warranty does not cover wear and tear or parts that have not been adequately or correctly maintained. THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
For warranty service, contact your local pet product dealer or write to the Catit ® representative in your country.

ACCESSORIES

Catit ® PIXI TM Fountain Filter replacement filter pads are available, sold separately.

SPARE PARTS

Pump (#44833) and USB Adapter (#44834)

catit 43715 Pixi Drinking Fountain SPARE PARTScatit logo

CATIT FOR YOU
Discover helpful product information & manuals, participate in contests, and enjoy loads of spectacular benefits! Go to catit.com, select your country and go to Catit For You in the site menu.
REGISTER YOUR PRODUCT
To improve your access to our customer support, register your product online. Click the registration button on the Catit For You page and enter your product code, which is made up of the last 6 digits of your product’s barcode.
GETTING STARTED
Click the Getting Started button on the Catit For You page to find loads of ultra-handy guides and instructional videos that help you get your Catit product up and running in no time!
TROUBLESHOOTING
Experiencing an issue with a Catit product? Click the Troubleshooting button on the Catit For You page to find many handy blogs that might solve your problem.
CUSTOMER SERVICE
You couldn’t find the answer to your problem on the troubleshooting web page? Contact our customer service by clicking the Contact button in the site menu.

Distributed by  :
Germany: HAGEN Deutschland GmbH & Co. KG, 25488 Holm
U.S.A.: Rolf C. Hagen (U.S.A.) Corp., Mansfield, MA 02048
U.K.: Rolf C. Hagen (U.K.) Ltd., Castleford, W. Yorkshire WF10 5QH
Canada: Rolf C. Hagen Inc., Montréal (Quebec) H9X 0A2
Spain & Portugal: Rolf C. Hagen España S.A., Av. de Beniparrell n.11 y 13, 46460 Silla, Valencia
Malaysia: Rolf C. Hagen (SEA) Sdn Bhd 43200 Cheras, Selangor D.E.
Argentina: Hagen S.A. Argentina, Rutherford 4459, Malvinas Argentina – CP 1615, Pcia. Bs.As.

Made in Malaysia
43715-43720
Printed in Malaysia
VER. 09/21 MORE INFORMATION
CATIT.COM

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals