tuya PIR313-Z-TY PIR Multi Sensor User Guide
- June 4, 2024
- Tuya
Table of Contents
tuya PIR313-Z-TY PIR Multi Sensor
Introduction
The PIR313-Z-TY is a Tuya ZigBee version multi-sensor that is used to detect movement, temperature & humidity, and illuminance in your property. It allows you to receive notifications from the mobile app When the human body movement is detected, you can receive the alert notification from the mobile phone application software and link with other devices to control their status. This guide will provide you with an overview of the product and help you get through the initial setup.
Get to know your device
LED indicator
The LED status gives the following information:
Reset button
- Join network. Press the reset button and release to view the device status on the network. When the device is in the network, the green light flashes three times; When not in the net, the red light flash three times.
- Reset. Press and hold the device reset button for five seconds until the device blinks green at a short time and enters the networking mode for one minute. After the networking succeeds, the device indicator turns off.
Anti-tamper button
When the rear cover of the device is installed, the anti-disassembly button is
pressed, and it belongs to the normal state. When the rear cover of the device
is removed, the anti-disassembly button is not pressed, and the anti-
disassembly alarm is triggered
Get started
To get started, you will need:
- A TUYA Gateway
- A mobile installed Tuya Smart APP
- A Tuya Zigbee Multi snesor
- Two D cell batteries
Connect to the gateway’s network
- Install batteries for the device.
- Reset the device. For details, refer to Chapter 2 > Reset button > Reset instruction content to operate;
- Open Tuya Smart APP to add devices. When the device is being added to the network, the green indicator blinks continuously. After the device is successfully added to the network or network add timeout(one minute later), the green indicator will turn off.
Method 1: Click the “+” icon in the upper right corner and choose Add
Device > Add Manually > Sensors > Motion Detector > Motion Detector (ZigBee)
for device addition.
Method 2: Click one of your gateways and then tap the “+ Add subdevice”
to add a device.
Note: If failed, please repeat the above step and try again.
Installation
You can mount the multi-sensor on the wall as a traditional motion sensor, or
you can choose to keep your multi-sensor on a bookshelf or table.
Wall mounting
Please peel off the liner on the double-sided tape and mount the sensor on the
surface of the wall.
- Please ensure that the surface is clean and secure.
- Install the multi-sensor in place where people are most likely to enter.
- Avoid mounting the multi-sensor close to pets, air conditioners, heaters, sunshine and places where the temperature varies.
Mount Example
Avoid Mounting：
Q &A
-
Question 1: How do I restore the sensor to its factory settings?
Answer 1: Press and hold the reset button for 5 seconds. When the indicator turns green, the reset succeeds. -
Question 2: How do I judge whether the sensor has been added to the gateway?
Answer 2: Press the reset button of the sensor once. If the red light blinks three times, it means that the sensor has not successfully joined the gateway; otherwise, the green light blinks three times, it means that the sensor has successfully joined the gateway
Technical Specifications
Safety Notice
WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the multi-sensor and other property. Read all the safety notices below before using the multi-sensor.
- Avoid high humidity or extreme temperatures.
- Avoid long exposure to direct sunlight or strong ultraviolet light.
- Do not drop or expose the unit to intense vibration.
- Do not disassemble or try to repair the unit on yourself.
- Do not expose the unit or its accessories to flammable liquids, gases or other explosives.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>