GALVANOX QAP10 Wireless Charging Pod Instruction Manual
- June 4, 2024
- GALVANOX
Table of Contents
Wireless Charging Pod
Instruction manual
How to use:
- Plug charger into USB Port
- Place the Airpod case onto the charger. LED will flash blue once charging
- If flashing red: check for debris between the product and charger
Technical Specifications
| Name | Wireless Charging Pod |
|---|---|
| Standard | QAP10 |
| SKU | QAP10WH |
| Input | DC 5V/1.5A |
| Output | 5W |
| Working frequency | 115-205KHz |
Safety Notice
- Do not pull the power cord forcefully or try to pull the power cord out.
- Do not try to disassemble the product.
- Do not submerge the product in water or other liquids.
- Do not use the product in extreme heat, humidity, or acidic environments
- Do not leave the product near open flames.
- Do not ingest the product.
FAQ
-
Why doesn’t the light stay on?
The is programmed to automatically turn off after a short period of time. This is a normal operation and the product is charging. -
Why is it hot?
Heat is a normal by-product of wireless charging technology. The product will be warm to the touch after a period of use. -
Why is it not working?
The product will show a red light if there is any interference with the charging coils. Please check to make sure there is no debris between the product and the charger. Additionally, ensure the product is securely plugged in.
FCC Warning
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
This device complies with part 15 of the FCC rules. operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>