veradek Pure Railing Planter Bracket Instructions
- June 4, 2024
- veradek
Table of Contents
BRACKET INSTRUCTIONS
Visitwww.veradek.com For More Information
PARTS
A – Planter Bracket – 3 PCS
B – Rail Bracket – 3 PCS
C – Slider Bracket – 3 PCS
D – Levelling Bar – 1 PC
E – Bottom Bolt – 6 PCS
F – Slider Bolt – 6 PCS
G – Rail Bolt – 6 PCS
H – Slider Nut – 6 PCS
I – Leveller Nut – 6 PCS
STEP 1
Attach Planter Bracket (A) to Rail Bracket (B) using 2 Rail Bolts (G). Tighten
using Phillips Screwdriver. Ensure Rail Bolt (G) is tight. Repeat for the
remaining 2 brackets.
STEP
2
Attach Slider Bracket (C) to Rail Bracket (B) using 2 Slider Bolts (F). Hand
tightens using Slider Nut (H). Ensure Slider Nut (H) is facing up. Repeat for
the remaining 2 brackets.
STEP 3 Attach assembled Planter Bracket to the planter. Place bracket hook over rear planter lip. Flip planter over. Screw 2 Bottom Bolts (E) into the bottom of the planter using a Phillips Screwdriver. Repeat for the remaining 2 brackets.
STEP
4
Hand tightens 1 Leveller Nut (I) onto each threaded rod of Leveller Bar (D)
about 1 inch deep. Place Leveler Bar (0) rods into bottom holes of Rail
Bracket (B) with the flat side facing away from the planer. Secure by hand
tightening a Leveller Nut (I) onto each rod.
STEP 5
Measure railing width. Adjust Slider Bracket (C) to match railing width. If
the railing is smaller than the slider width’s smallest opening, unscrew bolts
and turn the Slider Bracket around. Tighten (tightly) using pliers or an
adjustable wrench. Place planter on the railing. Adjust Levelling Nuts (I) to
obtain desired planter angle. Secure tightly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>