ergotron SV10-1100-0 HX Triple Bow Kit User Guide
- June 4, 2024
- ERGOTRON
Table of Contents
ergotron SV10-1100-0 HX Triple Bow Kit
What is in the box
installation instructions
- pull down
- tilt
- pull off
tools
NOTE: Arm extension should be at a 45 angle or less when attaching the crossbar.
Level Crossbar
OPTIONAL: Insert stop screw to lock portrait landscape monitor rotation.
CAUTION: Monitors are not stable unless fully secured to crossbar. Failure to tighten screws completely may result in damage to equipment.
Adjustment Step
Important YOu will need to adjust this product are installation is complete. Make Sure all your equipment is properly installed on tne product before attempting adjustments. This product should move smoothly and easily through the full range of motion and stay where you set it. if movements are too easy or difficult or if the product does not stay in desired positions, follow the adjustment instructions to create smooth and easy movements. Depending on your product and the adjustment, it may take many turns to notice a difference. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation.
Adjustment Step
Tilt-Forward and Backward
Increase Lift Strength f the mounted weight is too heavy or this product does not stay up when raised, then you’ll need to increase Lift Strength:
Lift-Up and down
Increase Lift Strength If the mounted weight is too heavy or this product does not stay up when raised, then you’ll need to increase Lift Strength:
Crossbar Hinge Adjustment
Increase Friction if this product moves too easily, then you’ll need to increase friction:
- Lift-Up and down
Increase Lift Strength if the mounted weight is too heavy or this product does not stay up when raised, then you’l need to increase Lift Strenath:
Adjustment Step
Crossbar Hinge Adjustment
Increase Friction If this product moves too easily, then you’ll need to increase friction:
Adjustment Step
Monitor Pan Adjustment
Increase Friction If this product moves too easily, then you’ll need to increase friction:
Adjustment Step
Crossbar Pan Adjustment
Increase Friction If this product moves too easily, then you’ll need to increase friction:
Safety
Warning: Because mounting surtace materials can vary widely, it is
imperative that you make sure mOunting surtace is strong enough to handle
mounted
product and equipment.
Caution: Leave enough slack in cable to allow full range of motion. To avoid the potential to pinch cables it is important to follow the cable routing instructions in this manual. Failure to follow these instructions may result in equipment damage or personal injury.
Safety
WARNING Stored Energy Hazard: The arm mechanism is under tension and will
move up rapidly, on its own, as soon as attached equipment is removed. For
his reason, DO NOT remove equipment unless the arm has been moved to the
highest position! failure to follow this instruction may result in serious
personal
injury and equipment damage
CAUTION: DO NOT rotate monitor past rear edge of desk. Doing so will create an unstable Situation and may cause equipment damage or personal injury.
Weight Capacity:
CAUTION: DO NOT EXCEED THE MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!
How to remove the monitor from the crossbar.
For the latest User Installation Guide please visit:
www.ergotron.com
For Warranty visit:
www.ergotron.com/warranty
For Service visit: www.ergotron.com
For local customer care phone numbers visit: http://contact.ergotron.com
Learn more about ergonomic
computer use
at:www.ergotron.com/ergonomics
NOTE: When contacting customer service, reference the serial number.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>