PRX PERFORMANCE Build Limitless® Squat Stand User Guide
- June 4, 2024
- PRx PERFORMANCE
Table of Contents
Build Limitless®
Squat Stand
WARNING: SERIOUS INJURY OR DEATH COULD OCCUR IF PRECAUTIONS ARE NOT TAKEN.
All questions, feedback, and return information should be sent to: support@prxperformance.com or call us at 1-701-566-0452
LIMITED LIFETIME WARRANTY:
This product is warranted by PRx Performance LLC, to the original user-owner only, against defective materials or workmanship for the lifetime of the product. During the warranty period or “lifetime” of the product, at the discretion of PRx management, if the product is found to be defective, it will be repaired or replaced without charge. This warranty does not cover defects in the product caused by ordinary wear and tear, abuse, misuse, overloading, accident (including shipping damage), improper maintenance, or alteration. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE OF THIS PRODUCT. PRx PERFORMANCE INC. SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES. Email support@prxperformance.com or call 701-566-0452. See full warranty at www.prxperformance.com
Build Limitless Squat Stand
All Parts & Tools Needed
| Item # | Description | QTY |
|---|---|---|
| 1 | Upright, 95″ or 81″ | 2 |
| 2 | 42″ Pull-Up Bar | 1 |
| 3 | 5/8″ x 4 1/2″Hex Bolt | 4 |
| 4 | 5/8″ Flat-Washer | 8 |
| 5 | 5/8″ Nylock Nut | 10 |
| 6 | 5/8″ x 4 1/4″ Hex Bolt | 6 |
| 7 | Spreader Plate | 1 |
| 8 | Support Foot | 4 |
| Tools Needed | Additional Items Needed (not included): | |
| --- | --- |
1. 15/16″ Open End Wrench
2. 15/16″ Socket
3. Socket Wrench
4. Step Stool
5. Second Person| 1. Floor Mounting Hardware
Squat Stand Assembly Instructions
- Attach the support feet to the uprights (Figures 2 & 3). It may be easiest to lay the uprights down on the floor on their side when doing this (Figure 3). Both front and rear support feet will be attached to the uprights at the same time. NOTE: Do not overtighten any of the bolts as this could result in deformed uprights and make it difficult to assemble additional components.
- Stand up one upright and attach the spreader plate to the rear angled foot. Erect the other upright with a second person holding the uprights and attach the spreader to the other rear-angled foot (Figure 2).
- Attach the pull-up bar (Figure 1).
- Anchor squat stand to the floor, then fully tighten all hardware.
Documents / Resources
| PRX
PERFORMANCE Build Limitless® Squat
Stand
[pdf] User Guide
Build Limitless, Limitless, Squat Stand, Stand
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>