CyMedica QB1 Electrode Placement User Manual
- June 4, 2024
- CyMedica
Table of Contents
CyMedica QB1 Electrode Placement
Introduction
The CyMedica electrodes are intended to be used with the CyMedica Orthopedics® NMES conductive garment. Refer to the provided NMES User’s Manual for Intended Use, Contraindications, Warnings, Precautions, and Adverse Reactions before operating the NMES System.
Explanation of Symbols
- The system is provided Non-Sterile
- Legal Manufacturer name and address
- Reference number; part number
- Lot number
- Follow instructions for use
- Consult instructions for use
- Expiration date
- Prescription-only (USA)
- CE Marking
- Authorized Representative
Electrode Placement Instructions
-
Electrodes must be placed on the garment in the labeled positions prior to use. Acquire electrode and electrode cover sets.
-
Identify the labeled electrode placement outlines and electrode wiring male connectors on the garment.
-
Remove and plug in a new electrode of the same size (2” x 2” or 2” x 3.5”) so that the male connector is completely covered.
-
Position the electrode and attach the rough side to the garment within the placement outlines.
-
Push electrode wiring back into the garment until connectors and wires are fully inserted.
-
Remove the clear plastic liner from top sticky surface of the electrode and discard.
-
Place the reusable electrode cover over the sticky surface of the electrode.
-
Repeat the process for the remaining two electrodes until all electrodes have been installed.
-
If you have an app-based device and this is your first time using the CyMedica NMES system, continue to download the appropriate app from the App Store for iOS or Google play for Android and follow the on screen instructions for use.
Electrode Replacement Instructions
- Electrodes must be replaced when they begin to deteriorate or lose adhesion. Note the orientation of the electrode to be replaced. Detach the electrode from the garment.
- Carefully pull the white wire connected to the electrode out of the garment until the second wire (black, blue, red) is exposed.
- Unplug the electrode wire.
- Discard the used electrode but keep the black electrode cover.
- Replace the discarded electrode by following the Electrode Placement Instructions section in this manual.
CE
MedEnvoy Global B.V. Prinses Margrietplantsoen 33 – Suite 123 2595 AM The
Hague The Netherlands CYMEDICA ORTHOPEDICS 2120 East 6th Street Suite 8 Tempe,
AZ 85281 USA
Customer Service: 1-844-CYM-2014
www.cymedicaortho.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>