Sleep & Study Loft Bed – Bookcase Assembly Instruction Manual
- June 2, 2024
- PB Teen
Table of Contents
Instruction Manual
PRE-ASSEMBLY:
-
For your safety and ease, assembly by two adults is recommended.
-
Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly when
used in conjunction with the assembly instructions. -
Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping
box provides and ideal work surface. Do not dispose of any contents until assembly is completed to avoid
accidentally discarding small parts or hardware. -
Use the parts and hardware lists to identify and separate each of the pieces included prior to starting assembly.
-
Note: DO not fully tighten the bolts until all parts are in place. Failure to follow these instructions may cause the
bolts to misalign during assembly. -
Do not use power drill as it may cause cracking.
HARDWARE LIST
ASSEMBLY INSTRUCTIONS:
- Slide a Spring Washer (D10) and a Flat Washer (D11) onto each Long/Short Bolts (D8 & D9).
- Attach Support Rail (D6) to bottom of the Center Shelf (D2). Insert (4) Long Bolts (D) with washers from
Support Rail (D6) into bottom of the Center Shelf (D2) by using Allen Key (D7). Note: Wooden cleat on the
Support Rail (D6) is close to surface of Center Shelf (D2) after assembly.
3. Place Side Panel (D4) on a soft, scratch-free surface with bottom wooden
blocks facing up. Attach (3) Shelf
(D1), Center Shelf (D2) and Bottom Shelf (D3) to Side Panel (D4) in sequence
as shown below. Insert (2)
Shorts Bolts (D9) with washers from wooden cleat of each shelf into Side Panel
(D4). Note: Wide apron of
Center Shelf (D2) and apron of Bottom Shelf (D3) face the edge without cut-out
on bottom.
4. Place Cork Panel (D5) onto the assembled piece. Secure each shelf to Cork
Panel (D5) by inserting (2) Short
Bolts (D9) with washers. Note: Cut-Out corner of the Side Panel and Corkboard
Panel face each other.
Place the assembled bookcase in upright position. Check alignments and tighten
all connecting bolts.
5. Assembly of Bookcase component completes.
CARE INSTRUCTIONS:
- Dust with a clean, soft cloth.
- Avoid the use of chemicals and harsh cleaning agents.
Sleep & Study Loft Bed – Bookcase Manual Optimized
Sleep & Study Loft Bed – Bookcase Manual Original