Portable Bluetooth Speaker NS-SPBTWAVE2 / NS-SPBTWAVE2-XX User Manual

: June 2, 2024
: Insignia

QUICK SETUP GUIDE

Portable Bluetooth Speaker

NS-SPBTWAVE2 / NS-SPBTWAVE2-XX

PACKAGE CONTENTS

Bluetooth speaker
USB cable
Quick Setup Guide

FEATURES

Wirelessly stream from any Bluetooth device
Rechargeable battery lasts up to 12 hours
Speakerphone for hands-free calling
Rubber feet support a horizontal or vertical orientation

features

IMPORTANT SAFETY INSTRUCTIONS

Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this speaker near water.
Clean only with a dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Only use attachments/accessories specified by the manufacturer.
Unplug this speaker during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the speaker has been damaged in any way, such as if the speaker is dropped, exposed to liquids, or does not operate normally.
Never expose the product to fire as this could result in personal injury.
Do not store the product in an extremely cold or warm environment.
Never dismantle the product.
Never let children play with the product.
Do not expose the product to dampness or moisture.
The product should not be exposed to dripping or splashing.
Note: The battery in this speaker cannot be replaced by the user.

CHARGING YOUR SPEAKER

Connect the small end of the charging cable to the micro USB port on the back of your speaker.
Connect the other end to a USB port on your computer or wall adapter (not included). The LED indicator is red while charging, then turns off when the speaker is fully charged.
Note: The speaker beeps continually when the battery is low. About five minutes
later, the speaker turns off automatically.

Charging

CONNECTING AN AUDIO DEVICE

Bluetooth

Press and hold (power) to turn on your speaker. The LED indicator blinks blue quickly and your speaker automatically enters pairing mode.
Make sure that your Bluetooth device is within 33 ft. (10 m) of your speaker.
Turn on your Bluetooth device, turn on Bluetooth, then enter pairing mode. For more information, see the documentation that came with your Bluetooth device.
On your Bluetooth device, select NS-SPBTWAVE2. Your speaker pairs with your Bluetooth device and the LED indicator lights solid blue.
To disconnect, un-pair your Bluetooth device from your speaker.
OR
Press and hold (call) for three seconds on your speaker. Your Bluetooth devices loses connection automatically.

Audio cable

Connect a 3.5 mm audio cable (not included) from your speaker’s AUX jack to your audio device’s headphone/audio out jack. The LED indicator blinks blue slowly while connected to an audio cable.

RECONNECTING TO A PAIRED DEVICE

When your speaker is not paired to a device, the LED blinks blue.

Reconnecting

Note: The Bluetooth range (33 ft./10 m) may be reduced if the wireless signal has to pass through walls or other obstructions.

USING YOUR SPEAKER

Listening to audio

Connect to your speaker with Bluetooth or an audio cable.
Play audio on your connected device.
Press + or – to adjust your speaker’s volume.
Note: Make sure that your connected device’s volume is set to at least 50%.
Use the controls on your connected device to control playback.

TAKING A PHONE CALL

Using your speaker

The following functions are available when paired to a phone with Bluetooth:

Reject an incoming call: Press and hold (call).
Answer an incoming call: Press (call).
Switch audio between your speaker and phone: Press and hold (call).
End current call: Press (call).
Redial the last dialed number: Press (call) twice.

LED indicator

SPECIFICATIONS

Dimensions (H × W × D): 6.77 × 2.75 × 2.75 in. (17.2 × 7 × 7 cm)
Battery size: 2,000 mAh
Wattage: 3W
USB cable length: 11.8 in. (30 cm)
Range: 33 ft. (10 m)
Run time: 12 hours
Charge time: 4.5 hours
Weight: 1.01 lbs. (0.46 kg)

TROUBLESHOOTING

Troubleshooting

LEGAL NOTICES

FCC

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures:

Reorient the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

RSS

IC Statement

This device complies with Industry Canada licence exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicable s aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suiv antes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accept er tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en comprom ettre le fonctionnement.

IFETEL Statement

La operación de este equipo está sujeta a las siguientes dos condiciones: 1. es posible que este equipo o dispositivo no cause interferencia perjudicial y 2. este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su propia operación no deseada.

ONE-YEAR LIMITED WARRANTY

Visit www.insigniaproducts.com for details.

CONTACT INSIGNIA:

1-877-467-4289 (U.S. and Canada)
01-800-926-3000 (Mexico)
www.insigniaproducts.com

INSIGNIA is a trademark of Best Buy and its affiliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2018 Best Buy. All rights reserved.
Made in China

Portable Bluetooth Speaker NS-SPBTWAVE2 / NS-SPBTWAVE2-XX User Manual – Optimized PDF
Portable Bluetooth Speaker NS-SPBTWAVE2 / NS-SPBTWAVE2-XX User Manual – Original PDF