HOMCOM IN231200187V01_GL Pressure Mounted Gate Instruction Manual

HOMCOM IN231200187V01_GL Pressure Mounted Gate

BEFORE USING PRODUCT

Improper installation could result in the Gate becoming unstable.

IMPORTANT

• Install according to manufacturer’ s instructions.
• This product will not necessarily prevent all accidents. Never leave pet unattended.
• STOP using when a pet can climb over or dislodge the gate.
• Use only with the locking/latching mechanism securely engaged.
• Check the gate regularly to see if all the hardware and mountings are tightened.
• Do not use if any components are missing or damaged.

WARNING

• Always ensure the gate is resting against the floor before beginning installation.

• Strangulation hazard: pets can force themselves into very small openings; use this gate with pets whose heads will not fit into openings in the gate, between the gate and floor, or between the gate and wall.

• If using this gate at the top of stairs, the four wall cups MUST be used. If not used, the gate may become dislodged from the opening.

• WARNING
  The gap between the gate and wall should not exceed more than 2.5 inches.

• NOTE : When installing any gate at its maximum width, use wall cups to ensure stability and safety.

PARTS

ASSEMBLING AND INSTALLING YOUR GATE

NOTE: You will notice a slight gap between the gate door latch and the frame. This is not a defect. Your gate is a pressure mounted gate and this gap will disappear once you tighten your gate in its opening.

NOTE: It may be necessary to hold the threaded spindle rods or rubber feet while rotating the adjustment wheels to ensure the entire unit does not rotate.

NOTE: There should be equal spacing among each of the (4) threaded spindle rods. Make the appropriate adjustment to ensure you have installed your gate safely.

POSITIONING AND ATTACHING THE WALL CUPS

OPERATING THE DOOR LATCH

NOTE: If your door latch is not properly engaging with the receiving component, ensure that your gate is level, mounted properly, and that you have not over-tightened the threaded spindle rods.

ADDING A GATE EXTENSION:

NOTE: Assemble the gate and extension as illustrated. Reposition the gate and in accordance with the gate fitting instructions.

REMOVING YOUR GATE FROM THE WALL

To remove your gate from the wall, rotate the adjustment wheels on each of the (4) threaded spindle rods to depressurize the gate from its doorway or opening. Then, gently pull or push the gate free from its doorway or opening.

CARE AND MAINTENANCE

• Periodically check the gate for signs of damage, wear, or missing components.
• Do not use if any part is missing, worn or damaged.
• Check the gate regularly to ensure all the hardware and mountings are tightened. Do not use abrasive cleaners or bleach.
• Clean by sponging with warm water and a mild detergent.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>