Canac 48178570 Maple Bathtub Installation Guide

June 1, 2024
Canac

Canac 48178570 Maple Bathtub

Canac-48178570-Maple-Bathtub-PRODUCT

Caution:  This new fixture has a durable finish; however, extra care should be exercised during installation, when rough handling and dropped tools may cause damage.

Instructions

  1. Inspect product, and if necessary, report damage to the distributor, requesting their advice on how to proceed.
  2. Protect the product during installation and construction by using this corrugated container as indicated. Cut along the dotted lines and place the cut-out corrugated protector into the center of the fixture.
  3. Measure product dimensions, then frame construction area to suit, using 2×4 stringer for support.

Canac-48178570-Maple-Bathtub-FIG-1

  1. Test-fit the product in position, checking for level front to back and left to right, as well as alignment of plumbing attachments. Ensure the floor provides solid flat and level support for the entire pad to rest upon. If not, flatten and level the floor to be solid (i.e. cured) with proper leveling compound applied in accordance with the manufacturer’s instructions. DO NOT shim the pad.
  2. Use roofing nails or drywall screws with washers to secure top of tile flange to wall studs as detailed:

Canac-48178570-Maple-Bathtub-FIG-2 Diagram Description
The diagram visually represents step 5 of the installation instructions. It shows a cross-sectional view of a wall stud, stringer, and bathtub edge. Indicated in the diagram is the location of a ‘Nail or Screw & Washer’ to secure the top of the bathtub tile flange to the wall stud.

  1. Drain assembly, faucet and the shower head should be installed to manufacturer’s specifications. Over-tightening the drain can damage this fixture. Caulking should be used to seal the gap between apron panel and floor.

CARE AND CLEANING

Clean with warm water, soft cloth or nylon brush, and a mild detergent like “ZUD” or “Barkeepers Friend” according to cleaner directions.
NEVER use abrasive scouring powders, cleaners or pads.

Specifications

Feature Requirement
Product Type Porcelain Enameled Bathtub
Installation Caution Handle with care to avoid damage
Support Use 2×4 stringer for framing construction
Attachment Secure with nails or screws & washers
Cleaning Use mild detergents, avoid abrasive cleaners

FAQ

What should I do if I find damage to the product upon inspection? Report any damage to the distributor immediately and request advice on how to proceed. Can I use any cleaner for the bathtub maintenance? No, only use non-abrasive cleaners like “ZUD” or “Barkeepers Friend” and avoid abrasive scouring powders, cleaners or pads. Is it necessary to use a corrugated protector during installation? Yes, to protect the bathtub, use the corrugated container as indicated in the instructions. How should I secure the bathtub to the wall studs? Use roofing nails or drywall screws with washers to secure the top of the tile flange to the wall studs.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals