Light Mix 389844 Warm White SR String Light User Manual
- June 1, 2024
- Light Mix
Table of Contents
Light Mix 389844 Warm White SR String Light
USER MANUAL
Indoor Use Only
LET THE LIGHT SHOW BEGIN!
Incorporating the latest DSP Technology,
LIGHT MIX LED String Lights pulse and blink to the beat of your music.
In Sound Responsive Light Show mode, the LED lights respond in perfect
synchronization to surrounding sound.
Beat detection is achieved by the Light Mix chip, which uses Digital Signal
Processing (DSP) technologies to analyze the frequency and amplitude of music.
This technology is very sensitive to low frequency sounds – creating a “Light Show” that is totally unique to the beat of your music.
Combined with a high quality built-in microphone, the string lights detect a dynamic range of sounds from 65db to 11 OdB.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authDlity to operate the equipment.
TURNING ON AND OFF
Press and hold for 2 seconds to turn on the unit Press and hold for 2 seconds to turn off the unit.
AUTO ON/OFF TIMER
There is a built-in timer of 6 hours. The unit will automatically tum off after shining for approximately 6 hours and on again after 18 hours.
CHANGING MODES
When turned on, the default mode Is Sound Responsive Ught Show.
Cycle through each mode by clicking the on/off button until the desired light
mode is achieved.
– Light Show (responds to music)
– Steady On
– Slow Pulse
– Blinking
TIP: To go qui:kly to Sound Responsive mode, tum the unit off and on again.
BATTERY
- Uses 3 AA batteries (not included).
- Replace batteries regularly to maintain brightness.
- Do not mix old and new batteries. Do not mix alkaline, standard (carbon-Zinc) or rechargeable (Nickel-Cadmium) batteries. Do not dispose in fire.
- When not used or in storage, remove the batteries from the unit.
- Dispose of old batteries according to your local regulation.
ltemNo.:XNL-11448
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, ? not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. It this equipment does cause harmful interference to radio or television reception, which can be detennined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circutt different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
© 2024 FSG
Light Mix® is a registered trademark of Fourstar Group Inc. Patent No.:
10,492,277, 10,945,327 and other patents pending. MANUFACTURED BY:
FOURSTAR GROUP USA,INC.
925 GRANT ST.,AKRON,OH 44311 USA
MADE IN VIETNAM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>