SUNCO LIGHTING 6 Inch Slim Baffle Downlight Installation Guide
- June 3, 2024
- Sunco Lighting
Table of Contents
The Brighter Choice
SLIM BAFFLE DOWNLIGHT 6”
Install Guide and Manual
A lightweight, plastic junction box eliminates conductivity and the need for a ground wire. Simply cap your existing ground wire!
COMPONENTS
IC Rated Junction Box
Located under cardboard at the bottom of the shipping box
EASY INSTALLATION
-
Turn off circuit breaker that provides power to the light switch for the recessed lights.
-
Cut a hole in the ceiling in the desired location accordingly to the dimension indicated.
-
Run electrical wire from the power source (switch) through the mounting hole.
-
Open the junction box and remove the appropriate knockout(s) on the side plate.
-
Connect the supply wires to the junction box wires using the wire nuts provided.
• White to white
• Black to black
• It is not necessary to ground a plastic junction box. Cap ground wire and tuck it into the non-conductive junction box. -
Close the cover.
-
Connect the junction box to the slim-down light.
Tighten the connector by hand. -
Insert junction box through the hole in the ceiling.
• New construction applications: Hardwire box shall be secured to studs, joists, or similar fixed structural units.
• Remodel applications: Do not require the hardwire box to be firmly secured after the mounting plates studs, joists, or structural units have been concealed.
-
Push up the spring clips to insert the luminaire in the opening of the ceiling.
-
Turn on the circuit breaker and test the light.
WARNING
All electrical connections must be in accordance with local and National Electric Code (N.E.C.) standards. Consult a qualified electrician if you are unfamiliar with proper electrical wiring connections. Please review instructions carefully before proceeding.
WARNING: Risk of fire or electric shock. Do not alter, relocate or remove
wiring during installation.
WARNING: Do not make or alter any open holes in an enclosure of wiring or
electrical components during kit installation.
WARNING: Gloves are required when accessing the junction box for any
routine maintenance.
WARNING: Not for use in ceilings with polystyrene insulation.
SPECIFICATIONS
| Voltage | Indoor |
|---|---|
| Wattage | Polycarbonate |
| Usage | 0.57lbs |
| Housing | 7 years |
| Weight | 120V |
| Warranty | 14W |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>