Euronda 816042 Aquafilter Instruction Manual

: June 1, 2024
: Euronda

Table of Contents

Euronda 816042 Aquafilter
Product Information
Product Usage Instructions
Storage instructions
Installation instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Euronda 816042 Aquafilter

Product Information

Specifications:

Product Name: Euronda O-Ring Kit 816042
Manufacturer: Euronda Spa
Ref Code: 816042
Revision Date: 11/2021

Product Usage Instructions

Safety Precautions:

Always handle the O-Ring spares with care to avoid damage.
Ensure proper disposal of used resins as hazardous waste.

Installation Instructions:

Inspect Components: Check all components (labeled A, B, C) in the O-Ring kit for any damage.
Assembly: Follow the provided Fig. 2 for step-by-step installation instructions.
Caution: Pay attention to step 2.3 to ensure proper installation and functionality.

Frequently Asked Questions (FAQ):

Q: How should I dispose of used resins?
A: Take used resins to a waste-disposal center and dispose of them as hazardous waste, following the laws of your country.

Q: What should I do if I encounter any issues during installation?
A: Refer to the provided installation instructions carefully. If problems persist, contact Euronda customer support for assistance.

Thank you for purchasing original Euronda spares.

Please note

Ion exchange resin cartridges should be replaced when the red indicator light on the Aquafilter lights up;
Once the new cartridges have been fitted, do not remove them until they have been used up, except where the following point applies;
Before an extended period of non-use of the Aquafilter, empty the system to prevent the formation of bacteria and biofilm;
To avoid compromising the performance of the device, both cartridges must be replaced;
It is recommended that you replace the vessels’ O-Ring seal (for guidance in selecting the seal, see Fig. 1);
The quality of the inlet water affects the durability of the resins. The higher the water-hardness and electrical-conductivity values, the fewer litres will be produced by the resin cartridges before a value of 15 microsiemens per cm stops the unit functioning. For example, if electrical conductivity is 300 μS/cm at the input, the quantity produced will be approximately 150 litres. For values near or above 600 μS/cm, the number of litres produced may be reduced by 30%. In this case, we recommend using the Aquaosmo reverse osmosis system.

Storage instructions

Store at a temperature between 5°C and 35°C;
Only remove from original packaging when fitting;
Avoid exposure to sources of light and heat;
Do not open or tamper with the cartridges.

Remember: take used resins to a waste-disposal centre and dispose of them as hazardous waste, complying with the laws in force in the country of use at all times.

Installation instructions

If possible, before replacing the resins, relieve the pressure on the vessels;
Unscrew the vessels containing the cartridges using the wrench supplied with the Aquafilter (Fig. 2.1);
Insert the spacer ring into the cartridge, ensuring that it is positioned correctly, then insert the cartridge into the vessel with the seal facing upwards (Fig. 2.2);
Screw the container back into the Aquafilter (Fig. 2.3);
Repeat this step with the second cartridge.

Fig. 1: O-Ring spares

Euronda-816042-Aquafilter-1