Megix PW02 Fast Charge Power Bank User Manual
- June 1, 2024
- Megix
Table of Contents
Megix PW02 Fast Charge Power Bank
FAST CHARGE POWER BANK
READING THE POWER METER
Checking your remaining power
- White lights indicate how much juice is left in your battery pack. If four white lights are showing, you’re fully charged.
- Three indicates a 75% charge, two for 50% and one for 25%.
Checking your charging function
A red light indicates that the powerbank is turned on, but is not actively
charging a device. A green light indicates a secure connection and power
delivery.
SAFETY
- If you’re not using your power bank often, please charge fully at least every three months.
- A small amount of heat production is normal. Please be aware of the optimal placement of the power bank, as incorrect placement on your phone can produce more heat.
- Keep the device dry and do not clean it with chemical agents
- If you are disposing of this power bank, please recycle it at your nearest battery recycling station.
- Usage by children should be supervised by adults.
- Do not crush, disassemble, or otherwise destroy this device.
- Do not store in hot, humid conditions.
- Make sure your device is compatible with your power bank before using it.
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment
The device has been evaluated to meet the general RF exposure requirement. The
device can be used be in portable exposure without restriction.
FAQ
My device isn’t charging. What is the problem?
- Make sure the power is on, and the power bank is charged.
- Make sure you’ve placed it in the proper position.
- Make sure your device is compatible with the power bank.
- If it still doesn’t work, please visit cellhelmet.com for support.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>