etiampro LQS05 Hidden LED Touch ON OFF Switch Furniture Panel User Manual
- June 1, 2024
- etiampro
Table of Contents
etiampro LQS05 Hidden LED Touch ON OFF Switch Furniture Panel User Manual
Mount
Connection
Product dimensions
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device
after its life-cycle could harm the environment. Do not dispose of the unit
(or batteries) as unsorted municipal waste; it should be taken to a
specialised company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Telemann! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, don’t
install or use it and contact your dealer.
Safety Instructions
Keep this device away from children and unauthorised users.
Keep this device away from rain, moisture, splashing and dripping liquids.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
Protect the device against extreme heat and dust.
General Guidelines
Refer to the Telemann Group NV® Service and Quality Warranty on the last pages of this manual.
- Familiarise yourself with the functions of the device before actually using it.
- All modifications of the device are forbidden.
- Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
Features and specifications
- This product is a unique design for Class III insulation appliance based on human touch application while touch switch installed inside/beneath wood board or other insulation materials.
- Function description: Install the touch dimmer inside or beneath the wood board (or other insulation material like marble ), switch on/off the light by short touch within 0.5 seconds on the surface of wood board. See image on page 2.
- suitable for: 12 and 24V LED strips
Installation
Determine the mounting location:
Determine where to place the touch switch. Choose a location for the touch
switch where the probability of unintended movement is minimal.
Glue the sensor with the power logo under the insulation material with a
maximum thickness of 32 mm (depending on the type of material).
Important!
First attach the switch with temporary tape to the back of the material and
test the operation. Try to reduce the thickness of the plate by a milling into
the material to improve operation.
Mount the LED Strip:
Mount the LED Strip in an aluminium profile.
Connect the wiring from the switch module of the PIR motion sensor to the LED Strip and connect the input of the switch module to an LED power supply. Connection diagram see page 2.
Technical Specifications
Physical properties
Cable length| 100 cm
Maximum current rating| 3 A
Input voltage rating VDC range| 12-24 V
Detection range| 32 mm
IP rating| IP20
Operating temperature range| 20-45 °C
Use this device with original accessories only. Telemann Group nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device. For more info concerning this product and the latest version of this manual, please visit our website www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Telemann Group nv.
All worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>