HALCYON S214 10w Single Circuit Dimmable Track Spot Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
S214 10w Single Circuit Dimmable Track Spot
Instruction Manual
S214 10w Single Circuit Dimmable Track Spot
This luminaire must be installed by a qualified Registered Electrician to
prevent damage to the luminaire and maintain electrical safety. If the
external flexible cable or cord of this luminaire is damaged, it shall be
exclusively replaced by the manufacturer or his service agent or a similar
qualified person in order to avoid a hazard.
The light source of this luminaire is not replaceable;
when the light source reaches its end of life the whole luminaire shall be
replaced.
Base plate,cable entry gland and screw heads must be covered in silicone
sealant. Failure to do so may cause luminaire failure from water ingress.
All exterior luminaires (with the exception of copper) require periodic
cleaning to protect the surface and/or coating from corrosion and ensure tidy
appearance for the lifespan of the product. Wash with care using a soft brush
and warm soapy water using a neutral detergent. Coastal areas require extra
attention, especially fittings which are under eaves/soffits and do not have
any exposure to rain. Do not use a water blaster or high pressure hose, do not
submerge fittings for extended periods of time. 316 stainless steel fittings
will still develop surface rust or “tea staining” if left uncared for.
Switch to “OFF” aligned with the “ ► ” at first, put the adaptor into the
track. Then turn the knob to the position which “ON” aligned with the “ ► ”.
FIG-2
Please make sure that the “Groove” on the section of track lines up with the
“Groove” on the track adaptor – failure to do so can potentially damage the
track adaptor and void any warranty.
PS: Step for Removing Luminaires
- Turn the knob to the position which “OFF” aligned with the “ ► ”.
- Take off the Adaptor from the track slantingly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>