HALCYON EX162 Surface Mount Column Spot Light Installation Guide
- June 10, 2024
- HALCYON
Table of Contents
HALCYON EX162 Surface Mount Column Spot Light
PRODUCT INFORMATION EX162
This luminaire must be installed by a qualified Registered Electrician to
prevent damage to the luminaire and maintain electrical safety.
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or his service agent or a similar
qualified person in order to avoid a hazard.
The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced.
Caution,risk of electric shock.
Baseplate, cable entry gland and screw heads must be covered in silicone
sealant. Failure to do so may cause luminaire failure from water ingress.
All exterior luminaires (with the exception of copper) require periodic
cleaning to protect the surface and/or coating from corrosion and ensure tidy
appearance for the lifespan of the product. Wash with care using a soft brush
and warm soapy water using a neutral detergent. Coastal areas require extra
attention, especially fittings which are under eaves/soffits and do not have
any exposure to rain. Do not use a water blaster or high pressure hose, do not
submerge fittings for extended periods of time. 316 stainless steel fittings
will still develop surface rust or “tea staining” if left uncared for
.”
INSTALLATION
FIG-2-B
Surface Mount
Please make sure the thickness of the installation surface is no less than 5mm
(E.g. Timber)
FIG-4
Upward installation
Note baseplate orientation
Downward installation
Note baseplate orientation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>