Siemens 9410SK Power Meter 9410 Instruction Manual
- June 10, 2024
- SIEMENS
Table of Contents
Siemens 9410SK Power Meter 9410
Product Information
The 9410SK is a sealing kit designed for the 9410 meter center. The kit is used to seal voltage and current inputs and also includes a revenue lock switch that can be sealed. The maximum sealing wire size is 2mm and must be supplied by the customer.
Product Usage Instructions
- Before working on the device or equipment, turn off all power supplying it and the equipment in which it is installed.
- Always use a properly rated voltage sensing device to confirm that all power is off.
- To seal voltage inputs, attach the sealing cover to the sealing point.
- To seal current inputs, attach the sealing cover to the two sealing points.
- Use the revenue lock switch to seal the device.
- When using the sealing kit, make sure to follow all safety instructions and warnings listed in the user manual to avoid potential hazards or personal injury.
- Installation, operation, servicing, and maintenance of electrical equipment should only be performed by qualified personnel who have received proper safety training.
WHAT’S INCLUDE
Safety
Safety precautions
DANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
- Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E in the USA or applicable local standards.
- Turn off all power supplying this device and the equipment in which it is installed before working on the device or equipment.
- Always use a properly rated voltage sensing device to confirm that all power is off.
- Do not exceed the device’s ratings for maximum limits.
Failure to follow these instructions will result in death or serious injury.
- Turn off all power supplying this device and the equipment in which it is installed before working on the device or equipment.
- Always use a properly rated voltage sensing device to confirm that all power is off.
Safety instructions
Read these instructions carefully and look at the equipment to become
familiar with the device before trying to install, operate, service or
maintain it. The following special messages may appear throughout this
bulletin or on the equipment to warn of potential hazards or to call attention
to information that clarifies or simplifies a procedure.
- The addition of either symbol to a “Danger” or “Warning” safety label indicates that an electrical hazard exists which will result in personal injury if the instructions are not followed.
- This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
DANGER indicates an imminently hazardous situation which, if not avoided,
will result in death or serious injury.
Electrical equipment should be installed, operated, serviced and maintained
only by qualified personnel. No responsibility is assumed by Siemens Industry
for any consequences arising out of the use of this material. A qualified
person is one who has skills and knowledge related to the construction,
installation, and operation of electrical equipment and has received safety
training to recognize and avoid the hazards involved.
Meter covers
Inputs sealing
Voltage inputs sealing
Current inputs sealing
ACCESS and Siemens Industry are trademarks or registered trademarks of Siemens Industry in France, the USA and other countries.
- This product must be installed, connected and used in compliance with prevailing standards and/or installation regulations.
- If this product is used in a manner not specified by the manufacturer, the protection provided by the product may be impaired.
- The safety of any system incorporating this product is the responsibility of the assembler/installer of the system. As standards, specifications and designs change from time to time, always ask for confirmation of the information given in this publication.
Siemens Industry
5400 Triangle Parkway
Norcross, GA 30092
www.usa.siemens.com/pds
NVE23949-00
© 2016 Siemens Industry. All rights reserved. 01/2016