Cattleya LCA2331-W Outdoor Wall Light Instruction Manual

LCA2331-W Outdoor Wall Light
Instruction Manual

INSTALLATION INSTRUCTIONS

LCA2331-W Outdoor Wall Light

OUTDOOR LIGHT

120VAC
READ AND FILLOW SAFETY INFORMATION
Turn off the main power at the circuit breaker before installing and servicing the fixture to prevent possible injury from electric shock.
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections, obtain the services of a qualified electrician.

INSTALLATION & ASSEMBLEY

Remove the fixture and the mounting package from the box and make sure that no parts are missing by referencing the illustrations on the installation instructions.

1. Carefully unpack all fixture parts and hardware and lay them on a clean workspace.
2. Attach the Mounting Plate to the Outlet Box by using the Mounting Screws.
3. Pull out the 3 wire power cords from the outlet box and go through the Mounting Plate.
4. Carefully inspect the fixture’s wires and connect the white supply wire to the white fixture wire, Connect the black supply wire to the black fixture wire and connect the ground supply wire to the ground fixture wire.
5. Gently tuck the wire connections neatly into the outlet box.
6. Install the Fixture Body over the mounting plate and Secure it with the two Fixture Screws through the Rubber Washers until tighten.
7. The Silicone Sealer is closed with at the connection between the wall and the lamp body wall seat.
8. Install the light bulb.
9. Restore power to junction box and test fixture.
10. Installation is complete.

SENSOR

• Motion sensors maximum range of 30 ft. and 220° detection angle. In addition, be aware of its 35° detection down-angle.
• Operating temperature: -30°C to 50°C

OPERATION MODES

Test Mode

| L/M/H| TEST| •SENSITIVITY ADJUSTMENT: Allows you to adjust the sensitivity of motion detector to a desired level at any time. When motion stops, the light will turn off in about 5 seconds.
Auto Detection
Mode| L / M / H| 2 MINUTES
or 6 MINUTES| •NORMAL MOTION DETECTION MODE: Motion detector turns your light on automatically after sensing moving heat sources in its coverage area at dusk to dawn, and stays on as long as motion is detected. When motion stops, light will remain on for the predetermined time you set (2 or 6 minutes) and then turn off automatically.
Dusk to Dawn
Mode

| L / M / H| DUSK TO DAWN| •DUSK-TO-DAWN OPERATION ONLY: Light turns on at dusk and off at dawn automatically, regardless of the presence of motion.

CARE AND MAINTENANCE

• Wipe clean with a soft dry cloth or electrostatic cloth. Always avoid using harsh chemicals and abrasives to clean clamps as they may damage the surface

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>