Carlofet 608 Launch Monitor Frame Mount Instruction Manual

Carlofet 608 Launch Monitor Frame Mount

Product Specifications

• Top Clamps
• Bottom Clamps
• Base Plate
• Large Screws
• Medium Screws
• Spacer
• Small Screws

Product Usage Instructions

1. Pull back the fabric flap on your Pro enclosure’s ceiling pipe where you plan to mount the launch monitor.
2. Loosely attach the base plate to the clamps using the medium screws. Center it on your enclosure.
3. Put the clamps over the pipe fitting and loosely secure the large screws. Use the spacer if needed to level the mount.
4. Fully tighten both sides of the clamps evenly to secure them in place.
5. Remove the base plate by unscrewing the medium screws once the clamps are in place.
6. Wrap the fabric flap around the pipe, cutting slits where the clamp’s screw holes are located.
7. Reattach the base plate to the clamps and tighten with the medium screws.
8. Secure the launch monitor mount to the base plate using the small screws.
9. Hang the launch monitor from the mount following the provided instructions and make final adjustments.

Frequently Asked Questions (FAQ):

Q: How can I contact customer support for further assistance?
A: You can send us an email at help@carlofet.com or give us a call at 608-352-0002 for any questions or assistance you may need.

Launch Monitor Frame Mount Instructions

1. To start, pull back the fabric flap on your Pro enclosure’s ceiling pipe where you plan to mount the launch monitor. Put the clamps over the pipe fitting and loosely secure the large screws.
   If one clamp is off the fitting, use the spacer between the clamp and base plate to level the mount.

2. Loosely attach the base plate to the clamps with the medium screws. Center it on your enclosure.

3. Fully tighten both sides of the clamps evenly to secure the clamps in place.

4. With the clamps in place, remove the base plate by unscrewing the medium screws.

5. Wrap the flap around the pipe. Then cut slits where the clamp’s screw holes are located. Do not cut the finished edge of the flap.

6. Reattach the base plate to the clamps and tighten with the medium screws.

7. Secure the launch monitor mount to the base plate with the small screws.

8. Hang the launch monitor from the mount as described in the instructions and make final adjustments.

Questions? Send us an email at help@carlofet.com or give us a call at 608-352-0002.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>