BABY born 824368 Soft Touch Girl Instructions
- June 12, 2024
- BABY born
Table of Contents
BABY born 824368 Soft Touch Girl Instructions
Features
-
Soft body.
BABY born Soft Touch has a soft body, i.e. the surface is easy to grasp and easy to push in. (Fig. 1)
This makes it easier to play with some of the doll’s features. (See no. 2 “I can drink” & no. 4 “I can cry”) -
I can drink. (Fig. 2)
Fill the BABY born Soft Touch bottle with fresh, cold tap water and tightly screw the drinking attachment onto the bottle.
Hold BABY born Soft Touch in your arms at an angle so that the tip of the bottle faces downwards and can be slid into the mouth of the doll.
Push it down until you feel resistance.
Now the doll can drink the water by squeezing the bottle repeatedly – about a third of the bottle’s contents.
If any water runs out of the mouth of BABY born Soft Touch while feeding, please reposition the tip of the bottle into an upright position and gently squeeze the sides of the bottle.
Warning : For use with cold water only. Other liquids can block the inside of the doll. -
I can soil my nappy. (Fig. 3)
BABY born Soft Touch needs to be fed water (refer to no. 2, “I can drink”). Put a BABY born Nappy on the doll. BABY born Soft Touch wets her nappy when you press her belly button.
Now BABY born Soft Touch needs a fresh nappy. -
I can cry. (Fig. 4)
BABY born Soft Touch can cry real tears.
BABY born Soft Touch only needs to drink water, see no. 2, “I can drink.”
Then grasp BABY born Soft Touch with both hands under her arms and press the middle of
her chest several times using your fingers or thumbs.
The tears start to flow.
If the desired effect does not materialise, please feed BABY born Soft Touch with clear water
again and press her chest again. -
I can eat. (Fig. 5)
BABY born Soft Touch can eat BABY born Food.
Prepare a bowl, spoon and one BABY born Food packet.
Preparation of BABY born Food:
Fill bowl with water up to the mark (approx. 12ml). Mix in the contents of the BABY born
Food packet with the spoon. Avoid the formation of clumps. The porridge has the right consistency when it is relatively thin and can be easily spoon-fed to BABY born Soft Touch. Hold
BABY born Soft Touch in your arms at an angle and spoon-feed the porridge to the doll.
Warning : Only for use with original BABY born Food, as the doll’s insides may otherwise become blocked.
Never put the porridge in the bottle. Otherwise it could get into a part of the BABY born Soft
Touch doll which is not meant for porridge and block it.
Please follow the cleaning instructions carefully!
The BABY born doll food consists of a sugar-starch mixture and poses no health hazard if inadvertently consumed.
Please mind the best before date printed on the bags.
BABY born Food is available online and from toy stores. -
I can do “number 1” and “number 2”. (Fig. 6)
6.1 BABY born Soft Touch can use the potty and do a “number 1”. (Fig. 6)
BABY born Soft Touch was fed with the bottle, so the corresponding tank is filled. Place the naked BABY born Soft Touch on the potty. Grip the doll’s belly with both hands, press down hard on her belly button and hold the pressure.
The water can now flow into the potty.
6.2. BABY born Soft Touch can go to the potty and do a number 2. (Fig. 6)
BABY born Soft Touch was fed with BABY born Food, so the corresponding tank is filled.
Place the naked BABY born Soft Touch onto the potty. Grip the doll’s belly with both hands, press down hard on her belly button and hold the pressure.
The content of the food tank goes into the potty. If both tanks inside BABY born Soft Touch are filled, pressing the belly button will empty them both at the same time.
6.3. BABY born Soft Touch can also do a “number 2” in her nappy.
Put on a new nappy and press her belly button after feeding while the doll is in a standing or sitting position. Press until all of the food has made its way into the nappy.
Warning! Please make sure all the food is removed! Please note the cleaning instructions and the instructions for changing nappies.
Important! After feeding and using the potty, the tube system inside BABY born Soft Touch should be cleaned immediately. -
I can take a bath. (Fig. 7)
BABY born Soft Touch can have a bath in the bathtub or be taken to the swimming pool. But she should not be fully immersed in water. Please do not leave the doll in direct sun light for an extended period of time (max. 1 hour).
For bathing BABY born Soft Touch, you should only use cold or tepid water, and only utilize common bath additives which are suitable for children. BABY born Soft Touch should not be fully immersed in bathwater, chlorine water or salt water for more than an hour, otherwise chemical reactions or bleaching could occur.
Please rinse and clean BABY born Soft Touch with clear water immediately after bathing.
Please follow the cleaning and drying instructions! Important!
1. Water can enter the tubes and tanks when playing in the bathtub. That is why the tube system inside BABY born needs to be cleaned immediately after a bath. To do so, read the cleaning instructions. (c.f. “Cleaning instructions”)
2. If water should get inside the doll, please empty it out before continuing to play with BABY born and use the doll’s functions.
3. BABY born Soft Touch is not suitable for use as a floatation device.
4. Do not use cosmetic products or skin care products on BABY born Soft Touch. -
I am even more flexible. (Fig. 8)
BABY born Soft Touch has a mobile head and mobile arms and legs. The shoulder joints can
be turned 360° to make dressing and undressing the doll with BABY born Clothing easier. -
I can sleep. (Fig. 9)
BABY born Soft Touch has sleeping eyes. Once BABY born Soft Touch is laid down, she
closes her eyes. BABY born Soft Touch is asleep. -
I don’t need batteries. (Fig. 10)
All described functions work mechanically. -
Cleaning instructions: (Fig. 11)
The cleaning process should be carried out by an adult only!
If BABY born Soft Touch gets dirty, she can be cleaned externally using a damp cloth.
Using tepid, soapy water makes it easier to clean the doll.
After bathing or feeding, the tube system inside BABY born Soft Touch should be cleaned immediately. If the doll is not cleaned, the remnants from the bathwater, chlorine water, salt water or food may block the tubing and tanks inside of the doll.
If the doll is used for an extended period of time without being cleaned, there is a risk of mould forming.
To clean BABY born Soft Touch in the correct way, fill the bottle with warm water and mild washing-up liquid and place the tip of the bottle halfway into the mouth of the doll pointing down (if the bottle were pushed all the way in, the water would enter the wrong tank). Once the bottle is empty, you should shake BABY born Soft Touch hard enough to loosen the remnants inside. Then place BABY born Soft Touch on her potty and press her belly button for an extended period of time, so the entire contents can come out. Repeat this process several times and rinse with clear water at least twice. Upon final rinse, there should not be anything visible in the rinse water. Leave BABY born Soft Touch on the potty for about 15 minutes after cleaning to make sure all the water has flowed out.
Important:
After cleaning with soapy water, the process should be repeated with a solution of vinegar and water to prevent mould stains and mould from forming. Mix a splash of regular vinegar with warm water. Then repeat the cleaning process described above using the vinegar solution. Finally, repeat the cleaning process with clear water at least twice. -
Drying instructions: (Fig. 12)
To dry BABY born Soft Touch, please place the doll on her back and put her arms in a vertical position. (Fig. 12) Then press her arms several times to remove any water still located in her arms. Repeat this step several times if needed.
Then position the doll upright. If there is water in the body, it will leak out of the two holes at the bottom of the upper body. If there is water in the legs, it will leak out of the two holes in the doll’s feet.
Shake the doll to find out if there is any remaining water in her arms, legs or body. Please repeat the above steps several times to make sure the doll is completely empty.
To dry BABY born Soft Touch, please carefully dry the doll and all her joints with a towel.
Finally, let BABY born Soft Touch air out at a warm and well aired location for a while.
Please note that drops of water may still leak out of the joints or feet or the holes in the doll.
Remove the leaking water with a dry towel and put a nappy on the doll.
IE: Zapf Creation (UK) Ltd., 50 Presley Way, Crownhill,Milton Keynes, MK8 0ES, Bucks, UK.
BABY born ® and are internationally registered trademarks of Zapf Creation AG.
©Copyright 2020 Zapf Creation AG
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>