BABY born 827321 Soft Touch Little Girl Instruction Manual

: June 12, 2024
: BABY born

Table of Contents

General information
Functions
Information on cleaning and drying
CUSTOMER SUPPORT
Documents / Resources

**BABY born 827321 Soft Touch Little Girl Instruction Manual

**

General information

We recommend carefully reading the user instructions before using the product for the first time and storing the instructions with the packaging in case you need them at a later point in time.
Rinse bottle thoroughly prior to use.
Please fill only with water.
After use, empty completely and leave to dry.

Functions

I can drink. (Image 1)
Fill the bottle that comes with the doll with clean, fresh tap water and screw the drinking attachment firmly onto the bottle.
Hold the doll across your arm at an angle so that the bottle tip is facing down and can be pushed straight into the doll’s mouth.
Fully insert the tip of the bottle.
The water can now be fed to the doll by gently and repeatedly squeezing the bottle – approx. one-third of the content.
The water tank is full when water flows from the doll’s mouth.
Warning: Use fresh water only. Other liquids can block the tubes and tanks inside the doll.
I can soil my nappy. (Image 2)
The doll must be fed with water; refer to “I can drink”.
Please put a fresh BABY born nappy on the doll.
The doll does a wee in her nappy after pressing the belly button.
The nappy becomes wet. Now the nappy can be changed.
The wet nappy can be dried and reused.
Hand-wash the cloth nappy to clean it.
I can cry. (Image 3)
The doll can cry real tears. To do so, the doll must be fed with water; refer to “I can drink”.
Then grasp the doll with both hands under her arms and press the middle of her chest several times using your fingers or thumbs.
The tears start to flow.
If the desired effect does not materialize, please feed the doll with clear water again and then press the middle of her chest.
I can do a wee-wee. (Image 4)
The doll can use the potty and do a wee-wee.
She was fed with water, i.e. the respective tank is full.
Put the unclothed doll on the potty.
Wrap both hands around the doll’s belly and firmly press and hold the belly button.
The water then runs into the potty.
The doll is doing a wee.
I can take a bath. (Image 5)
If the doll is bathed at home, please only use the BABY born bathtubs or bathe the doll in a suitable container.
When bathing, use cold or tepid water and choose commercially available bath additives suitable for children.
If the doll is taken to a swimming pool or the beach, please do not play with the doll in the chlorine water or salt water for longer than 1 hour, as chemical reactions or bleaching of the doll may occur.
The 1-hour limit also applies to the bathwater in the BABY born bathtub or the container suitable for dolls.
The doll should not be submerged completely under water.
It is essential that you rinse and clean the doll with clear water after bathing.
If water has entered the doll, please remove the water before playing with and using the functions of BABY born.
Observe the information on cleaning and drying.
When playing with the doll in the BABY born bathtub or other suitable container, water can enter the tubes and tanks.
It is therefore vital to clean the tube system inside the doll immediately after bathing.
Please read the information on cleaning for further details.
Important: Avoid bathing the doll together with your child in the bath.
Incomplete cleaning and/or drying after a previous bath could result in unhealthy germs and bacteria forming inside the doll.
The doll is not suitable for use as a floatation device.
Do not use cosmetic or skin care products on the doll.
Do not leave the doll in direct sunlight for extended periods of time (max. 1 hour).
Do not subject the doll to high temperatures (45°C or higher) for extended periods of time.
I am mobile. (Image 6)
The doll has a moveable head, arms and legs.
The shoulder joints can be rotated 360° to make it easier to put on and take off her BABY born clothes.
I can sleep. (Image 7)
The doll has sleeping eyes. As soon as she is laid down, her eyes close and she falls asleep.

Information on cleaning and drying

To be done by an adult.

Exterior cleaning:
In case of external soiling, the doll can be cleaned using a damp cloth. It is easier to clean the doll using warm soapy water.

Interior cleaning:
Fill the bottle with warm water and mild washing-up liquid and feed the doll. (FIG. 8) Refer to “I can drink”.

To clean the wee-wee function (FIG. 9), sit the doll on her potty and press the belly button long enough to make sure that the entire content flows out of the doll.

Repeat this procedure several times and rinse with fresh, clean water at least twice.
After cleaning, leave the doll on her potty for about 15 minutes to ensure that all water has run out.
Then put a dry nappy on the doll.
To clean the crying function (FIG. 10), press the chest several times so that the water is pushed into the eyes (refer to “I can cry”).
Repeat this process several times until the water stops flowing and the tank and tubes are empty.
Wipe the mouth, face and eyes with a dry cloth and leave to air dry.

Important:
To prevent the formation of mould and mould stains, the doll should be cleaned with diluted vinegar after cleaning with washing-up liquid.
To do this, add a splash of commercially available vinegar to warm water.
Repeat the cleaning procedure described above with this diluted vinegar.
Finally, perform the cleaning process with fresh water at least twice.

Drying: (FIG. 11)
To remove any water from the doll’s arms, spread the arms so that the holes in the armpits are visible.
Rotate the doll back and forth until there is no water left.
Now hold the doll upright.
If there is any water in the body, it will flow out of the two holes provided at the bottom of the body.
If there is water in the legs, it will flow out of the two holes in the soles of the feet.
You can check whether there is still water in the doll’s arms, legs or body by shaking it briefly.
Therefore, repeat the process described above several times in order to empty the doll completely.
To dry the doll, please pat the doll and especially all the joints dry carefully using a towel.
Lastly, leave the unclothed doll to air in a dry, well-ventilated and warm place for an extended period of time.

Please note: that water droplets may still come out of the doll’s joints, feet or the two holes.
Therefore, put a nappy on the doll and remove any leaking water with a dry cloth.
Cleaning Instruction

CUSTOMER SUPPORT

Zapf Creation (UK) Ltd., 50 Presley Way, Crownhill, Milton Keynes, MK8 0ES, Bucks, UK.
Disposal Icon

BABY born® and are internationally registered trademarks of Zapf Creation AG.
© Copyright 2021 Zapf Creation AG
ZAPF CREATION AG
Mönchrödener Straße 13
96472 Rödental
GERMANY
www.zapf-creation.com
Made in China

Documents / Resources

| BABY born 827321 Soft Touch Little Girl [pdf] Instruction Manual
827321, 827338, 827789, 827796, 828762, 828779, 831960, 831977, 833407, 833414, 833650, 827321 Soft Touch Little Girl, Soft Touch Little Girl, Little Girl, Girl
---|---