VOLLRATH 1776-11 Cayenne Colonial Kettle Warmers and Rethermalizers Instruction Manual
- June 1, 2024
- VOLLRATH
Table of Contents
VOLLRATH 1776-11 Cayenne Colonial Kettle Warmers and Rethermalizers Instruction Manual
Thank you for purchasing this Vollrath Equipment. Before operating the equipment, read and familiarize yourself with the following operating and safety instructions. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Save the original box and packaging. Use this packaging to ship the equipment if repairs are needed.
Register your product on-line atwww.vollrath.com
Safety Precautions
To ensure safe operation, read the following statements and understand their meaning. Please read carefully.
⚠ WARNING
Warning is used to indicate the presence of a hazard that can cause severe
personal injury, death, or substantial property damage if the warning is
ignored.
⚠ CAUTION
Caution is used to indicate the presence of a hazard that will or can cause
minor personal injury or property damage if the caution is ignored.
NOTE
Note is used to notify people of installation, operation, or maintenance
information that is important but not hazard-related.
For Your Safety!
These precautions should be followed at all times. Failure to follow these
precautions could result in injury to yourself and others.
To reduce risk of injury or damage to the equipment:
⬜ Use only grounded electrical outlets matching the nameplate rated voltage.
⬜ Use equipment in a flat, level position.
⬜ Do not use an extension cord with this equipment. Do not plug this equipment
into a power strip or multi-outlet power cord.
⬜ Unplug equipment, turn off and let it cool before cleaning or moving.
⬜ Unplug equipment when not in use.
⬜ Do not operate without water.
⬜ Do not spray controls or outside of equipment with liquids or cleaning
agents.
⬜ Do not clean the equipment with steel wool.
⬜ Keep equipment and power cord away from open flames, electric burners or
excessive heat.
⬜ Do not operate unattended.
⬜ Do not operate equipment in public areas and/or around children.
⬜ Do not operate if equipment has been damaged or is malfunctioning in any
way.
Function and Purpose
The 1000W models are intended and designed to prethermalize containers of
refrigerated, previously cooked food and hold containers of hot food at safe
serving temperatures. All models are intended and designed to keep food
product at proper serving temperatures. Food must be prepared and placed in
all models at proper serving temperatures for hot food holding mode.
These units are not designed to cook raw food.
Unpacking the Equipment and Initial Setup
When no longer needed, dispose of all packaging and materials in an environmentally responsible manner.
- Remove all packing material and tape, as well as any protective plastic from the equipment.
- Clean any glue residue left over from the plastic or tape.
- Place the equipment in the desired location.
- Plug the equipment into a properly grounded electrical supply matching the nameplate rating. Damage to the equipment can occur if incorrect power is supplied to equipment.
Features and Controls
(A) ON/OFF HEAT CONTROL SWITCH. Switches the equipment power ON or OFF
and is used to set or adjust the temperature of the well.
The higher the number the higher the temperature, the lower the number the
lower the temperature. Rotating the control switch all the way in the
counterclockwise direction switches the unit OFF.
Operation
⚠ WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the unit. Liquid
inside the unit could cause an electrical shock. Do not damaged power cord.
Do not over fill wells, pans or trays. Liquid could contact the electrical
components and cause a short circuit or an electrical shock. Unplug unit
before performing service, draining or removing spillage pans and trays. Do
not spray water or cleaning products.
Do not use a power cord that has been modified or damaged.
⚠ WARNING
Burn Hazard
Do not touch hot food, liquid or heating surfaces while equipment is heating
or operating.
Hot surfaces, steam and food can burn skin. Allow the hot surfaces to cool before handling. Do not drop or spill water onto the cooking surface as it can spray or splatter.
- Fill the well to the correct level marks with clean fresh water. Correct level is about 1-1/2” (2.8 CM) or approximately 4 cups (1 Lt.) of water. Do not over fill. See Figure 1.
- Plug electrical power cord into a grounded outlet matching the nameplate rated voltage.
NOTE:
If using fractional size pans, adapter bars must be used to keep steam from
escaping from between pans.
Rethermalizing refrigerated food that has been previously cooked:
-
Preheat the water in the well by covering well with empty food containers or covers, and then turning the unit ON and set the on/off heat control switch (A) to the maximum heat setting. Preheat for 15 minutes.
-
Place covered container of chilled food product to be rethermalized into equipment. See food safety precautionary note.
-
During the rethermalization process, monitor food temperatures closely for food safety. The United States Public Health Service recommends that the entire food product reaches and maintains a minimum of 165°F (74°C) for at least 15 seconds to be properly rethermalized. In addition, rethermalized food must pass through the danger zone of 40°F (4° C) to 165°F (74°C) in less than 2 hours to prevent growth of organisms of public health concern. Do not add cold food for rethermalizing while holding hot food.
NOTE:
To reach the required safe food temperature as quickly as possible, do not add water or remove food pan during the rethermalization process. -
Reduce heat setting to a level that will maintain a safe holding temperature and maintain food quality. See food safety precautionary note.
Hot Food Holding:
-
Preheat the water in the well by covering well with empty food containers or covers, and then turning the unit ON and setting the on/off heat control switch (A) to the maximum heat setting. Preheat for 15 minutes.
-
Place container of hot food product, above 140 °F (60 °C), into preheated equipment.
-
Reduce heat setting to a level that will maintain a safe holding temperature and maintain food quality. See food safety precautionary note.
Food Safety Precautionary Note:
Monitor food temperature closely for food safety. The United States Public Health Service recommends that hot food be held at a minimum of 140 ºF (60 ºC) to help prevent bacteria growth. Maintain correct water level and temperature setting. Periodically remove food container and check the water level. Add water if needed.
During operation:
-
Maintain water level at or near water level mark. Periodically (approximately 2 hours) remove container of food and check the water level. Add hot water if needed. Some models are equipped with a low water indicator light (D) that illuminates when the water level is low.
When finished using the equipment: -
Turn the on/off heat control switch (A) to the OFF position and unplug unit. When removing hot food containers from unit use gloves, mitts or pot holders to protect hands.
-
Allow the unit and water to cool completely.
Cleaning
To maintain the appearance and increase the service life, clean your equipment daily.
⚠ WARNING
Burn Hazard
Do not touch hot food, liquid or heating surfaces while equipment is heating
or operating.
Hot surfaces, steam and food can burn skin. Allow the hot surfaces to cool
before handling. Do not drop or spill water onto the cooking surface as it can
spray or splatter.
NOTE:
Do not use caustic cleaning chemicals, steel wool or commercial lime
removal products to clean the equipment.
Thoroughly rinse equipment with water after cleaning.
7. Turn the on/off heat control switch (A) to the OFF position and unplug
unit. When removing hot food containers from unit use gloves, mitts or pot
holders to protect hands.
8. Allow the equipment to cool completely before cleaning.
⚠ WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the unit. Liquid
inside the unit could cause an electrical shock. Do not damaged power cord.
Do not over fill wells, pans or trays. Liquid could contact the electrical
components and cause a short circuit or an electrical shock. Unplug unit
before performing service, draining or removing spillage pans and trays. Do
not spray water or cleaning products.
Do not use a power cord that has been modified or damaged.
NOTE:
Do not immerse the cord, plug or equipment in water or any other liquid.
9. Dispose of the water.
10. Using a damp cloth, sponge dipped in soapy water to clean the inside of
the well and the outside of the equipment.
Troubleshooting Chart
Service and Repair
There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the equipment or replace a damaged power cord yourself. Do not send equipment directly to The Vollrath Company LLC. Please contact Vollrath Technical Service from the list below.
VOLLRATH Technical Service •
1-800-628-0832 •
1-920-457-4851
• Vollrath Warmer Repair Service •
1-800-354-1970
• Email techservicereps@vollrathco.com
When contacting Vollrath Technical Service, please be ready with the item number, model number (if applicable), serial number, and proof of purchase showing the date the unit was purchased.
Warranty Statement for The Vollrath Co. L.L.C.
This warranty does not apply to products purchased for personal, family or household use, and The Vollrath Company LLC does not offer a written warranty to purchasers for such uses.
The Vollrath Company LLC warrants the products it manufactures or distributes against defects in materials and workmanship for a period of one year, except as specifically described in our full warranty statement. In all cases, the warranty runs from the date of the end user’s original purchase date found on the receipt. Any damages from improper use, abuse, modification or damage resulting from improper packaging during return shipment for warranty repair will not be covered under warranty.
For complete warranty information, product registration and new product announcement, visit www.vollrath.com.
The Vollrath Company, L.L.C.
1236 North 18th Street
Sheboygan, Wisconsin
53081-3201 USA
Main Tel: 920-457-4851
Main Fax: 920-459-6573
Service Tel: 920-457-4851
Service Fax: 920-459-5462
Vollrath Europe BV
Beneluxbaan 7
5121 AD RIJEN
The Netherlands
+31161870005
Vollrath of China
Vollrath Shanghai Trading Limited
29D, 855 South Pu Dong Road
Shanghai, China 200120
Tel: 86-21-50589580
Vollrath de Mexico S. de R.L. de C.V.
Periferico Sur Edificio 2-C
Col. Santa Maria Tequepexpan
45601 Tlaquepaque, Jalisco Mexico
Tel: (52) 333-133-6767
Tel: (52) 333-133-6769
Fax: (52) 333-133-6768
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>