SENSYS networks FlexMag3 Wireless Magnetometer Sensor User Guide
- June 1, 2024
- SENSYS Networks
Table of Contents
SENSYS networks FlexMag3 Wireless Magnetometer Sensor
Before you begin install, you will need
A Electric or Pneumatic drill with 68mm or 2-5/8” Drill Bit, a Vacuum cleaner and a depth measuring tool are recommended. You may also need a blow torch to dry up wet holes.
-
FlexMag3 sensors for installation
-
Burst Pack with adhesive 2 part liquid and a depth tool
STEP-1
sing a pneumatic or electric drill, drill a 2-5/8” or 68mm diameter hole,
3.25”/82.5mm deep. Use blow torch to dry hole if wet.
FCC/IC Warning
RF Exposure| This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment This equipment should be installed
and operated with minimum distance 20cm between the radiator& your body. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitte
---|---
safety| 2006/95/EC
---|---
EMC|
- FCC: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1). This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- CE0678
- 2004/108/EC
- IC: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device
STEP-2
Squeeze end of pouch containing Part A towards primary burst seal, applying
even pressure until primary burst seal slowly ruptures allowing Part A to mix
with Part B
STEP-3
Knead pouch until Part A and Part B are thoroughly mixed for no more than 10
seconds
STEP-4
Remove cap, point pouch into the hole, squeeze pouch to burst secondary seal
and pour the liquid in to the hole using depth tool to fill until adhesive
just touches depth tool, 2.75” or 70mm from top of the hole,
STEP-5
Place sensor with label up and the arrow pointing in the direction of traffic
within 15 seconds of previous step to about 1/8” or 3mm from surface. Place
the remaining adhesive from burst pack into the hole fully encapsulating the
sensor
Note: Before starting the sensor installation process, please make sure to read all steps completely. Steps 2 to 5 should be completed within a total of 1 minute.
CUSTOMER SUPPORT
Local Distributor
Sensys Networks and the Sense’s Networks logo are trademarks of Sense’s
Networks, Inc. All other trademarks are the property of their respective
owners.
Information contained herein is believed to be reliable, but Sensys Networks
makes no warranties as to its accuracy or completeness.
Copyright © 2023 Sensys Networks, Inc. • ALL RIGHTS RESERVED • P/N
152-240-100-014 Rev D
Documents / Resources
|
SENSYS networks FlexMag3 Wireless Magnetometer
Sensor
[pdf] User Guide
FlexMag3 Wireless Magnetometer Sensor, FlexMag3, Wireless Magnetometer Sensor,
Magnetometer Sensor, Sensor
---|---