HOWDENS LAM2379 Series 90cm Premium Canopy Cooker Hood Instruction Manual

HOWDENS LAM2379 Series 90cm Premium Canopy Cooker Hood

Product Information

• The Premium Canopy Cooker Hood is designed to efficiently extract cooking fumes and odours from your kitchen, ensuring a clean and fresh environment while you cook.
• This hood comes in two sizes, 60cm and 90cm, to suit different kitchen layouts and cooking needs.

FAQ

• Q: Can I install the cooker hood by myself?
• A: It is recommended to have a suitably competent and qualified person install the cooker hood to ensure proper fitting and safety.
• Q: How often should I clean the filters?
• A: The frequency of filter cleaning depends on your cooking habits, but it is advisable to clean or replace filters every 3-6 months for optimal performance.

60cm / 90cm Premium Canopy Cooker Hood

• Please read the Installation instructions to ensure safe fitting and use of the appliance.
• The appliance should be fitted by a suitably competent and qualified person.
• Please keep these instructions in a safe place for future reference.
• Danger of suffocation, keep packaging material away from children.

Declaration of conformity

We declare that our products meet the applicable European Directives, Decisions and Regulations and the requirements listed in the standards referenced.
EC Regulation 1275/2008 for standby

Installation Instructions

Warning and Safety Information

Check for visual damage. If damaged, do not use. See guarantee: What to do if you need to report a problem.

Throughout this manual the following warning symbols are used.

Warning and Safety Information

• Please read these instructions carefully. The manufacturer is not responsible if an incorrect installation and use causes injuries and/or damage. Always keep these instructions with the appliance for future reference.
• Please take appropriate care when installing, maintaining, cleaning and operating this appliance.

Correct application

• This appliance is intended for domestic extraction only. It must not be used for other purposes. Commercial and any other use will be considered improper and will void the guarantee.
• The manufacturer shall not be liable for any damage caused by improper use, installation or handling errors.

Safety for children and vulnerable people

• Electrical products can be dangerous to children. Keep children away from the product when it is operating and do not allow them to play with or near the appliance.
• The packaging materials will be dangerous for children. Keep the packaging materials away from children.

General safety

• Do not operate the product if the power cable is damaged. Call a qualified service agent.
• Do not carry out any repairs or modifications on the product. However, you may remedy some problems that do not require any repairs or modifications. See page 16 “Troubleshooting” section of the USER Instructions.
• Never wash down the product with excessive water, as there is the risk of electric shock.
• The appliance must be disconnected from the mains during installation, maintenance, cleaning and repair procedures.
• Repair procedures must always be performed by qualified service agents. The manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons. This may void the warranty.
• Do not trap the mains cable and do not route it over surfaces that may become hot. The cable insulation may melt and cause a fire as a result of a short circuit.
• Do not look directly into the lamps through optical devices – binoculars, magnifying glasses etc.
• The appliance must be installed by a person under the regulations in force, otherwise the guarantee may become void.

Safety when working with electricity

• In case of any damage, switch OFF the product and disconnect it from the mains. To do this, turn off the fuse at the fuse box.
• Make sure the fuse rating is compatible with the product.

Electrical connection

• The appliance must be connected to fixed wiring via the use of a double pole switched, fused spur outlet with at least 3mm contact separation. The isolation switch must be accessible after installation.
• Before connecting this appliance, ensure that the connection data on the data plate (fuse rating, voltage and frequency) match the mains electricity supply. If in any doubt, consult a qualified electrician.
• Technical specifications and compatible consumables can be found on page 22.
• The reliable and safe operation of this appliance can only be assured if it has been connected to the mains electricity supply.
• WARNING: This appliance must be earthed.
• The electrical connection must comply with current local and national safety regulations (BS 7671) in the UK.

If in any doubt, please have the wiring system of the building tested by a qualified electrician. LAMONA cannot be held liable for the consequences of an inadequate earthing system (e.g. electric shock).

Do not connect the appliance to the mains electricity supply via:

• A multi-socket adapter.
• Multiple connectors.
• An extension lead or similar.
• The appliance must not be used with energy-saving plug devices.

• The appliance will not function correctly and may overheat.

The electrical socket must be easily accessible after installation so that the machine can be disconnected from the electricity supply if necessary.

• In the event of a fault, the appliance must be isolated from the electrical supply.
• Do not touch the appliance when hands or feet are damp or wet.
• Avoid damaging the mains plug and cable. If a replacement is required, contact a LAMONA authorised service agent, or a suitably qualified person.

Do not power on until correctly installed

Caring for the environment

Disposal of the packing material

• The environmentally friendly recyclable packaging is designed to protect the appliance from damage during transportation. All packaging materials should be recycled. Recycling reduces the use of raw materials in the manufacturing process and also reduces the amount of waste in landfill sites.

Packaging of this appliance is recyclable and may include:

• Cardboard.
• Paper.
• Polythene foil (PE).
• CFC-free polystyrene (PS hard foam).
• Polypropylene tape (PP).

This appliance carries the symbol of a crossed-out dustbin to state that segregated processing is compulsory to avoid any negative effects on the environment and public health. At the end of its life it must be disposed of at a special refuse centre run by your local authority or dealer.
Segregated processing enables the recovery of the materials used in the production of this appliance, thus saving considerably in terms of raw materials and energy.

Installation considerations

Methods of extraction

The very best method of clearing the kitchen of unwanted odours is by connecting the appliance to an exhaust duct and venting to the outside atmosphere via the ceiling or an exterior wall. Suitable ducting kits may be purchased from your local Howdens depot or online.
You do not need carbon filters when using the external ducting mode.

Extraction via exhaust ducting (vented outside) – no carbon filters required

• Ducting kits are supplied separately.
• Never use the hood in areas where devices with exhaust pipes connected to the outside are already operating unless perfect ventilation can be guaranteed.
• There must be adequate ventilation in the room when the cooker hood is used at the same time as an appliance burning gas or other fuels.
• Connect the external ducting kit to the outlet of the cooker hood.

Carbon filters are not required if the hood is to be ducted out.

Extraction via recirculation (vented internally) – carbon filters required

• For extraction via recirculation, install carbon filters.
• These can be ordered separately from your local Howdens Depot or online. Part No. LAM2014.
• Ensure power is switched off to the cooker hood before installing/changing the carbon filters.
• Ensure that air can escape the cabinet.

Components

Part identification

• On opening the packaging, remove and identify each part.
• Carefully place each part on a clean, scratch-free surface.
• Do not scratch the finished surfaces.

• Use only screws and small parts in support of the cooker hood.
• Failure to install screws/fixings under these i nstructions may result in electric shock.

Product dimensions and minimum dimensions

External dimensions

Minimum dimensions

• Please check these minimum distances. These are necessary for correct installation of the appliance.
• 150mm between the top of the cabinet and the ceiling when in recirculation mode to allow air flow and stop noise.

Half-height cabinet preparation

Remove back panel

Remove support rail

Remove bottom panel

Create a cut-out to accept the cooker hood

Install the cooker hood

With the cabinet mounted on the wall install the cooker hood

• Take care not to damage the cooker hood or cabinetry.
• Two people are needed to install/secure the cooker hood.

Secure with 4 flange head screws

Extraction via exhaust ducting (vented outside)

• The cooker hood fills the half-height cabinet. Ducting needs to be considered on top of the cabinet.

Tips for optimal air extraction

• Keep duct-work short and straight.
• Do not reduce the size or diameter of the duct.
• Keep duct-work taught to minimise pressure loss.

Extraction via recirculation (vented internally)

• Grille used from separate ducting kit. Fitted to stop any debris falling in to the fan motor and causing damage.

CAUTION
A carbon filter must be fitted when venting internally,

Full height cabinet preparation

Remove centre upright

Remove bottom panel

Cut holes in the top panel and shelf for 150mm ducting

Locate the shelf and secure using screws through the back panel

Relocate the bottom hinges to accommodate the cooker hood

Install the cooker hood

With the cabinet mounted on the wall install the cooker hood

• Take care not to damage the cooker hood or cabinetry.
• Two people are needed to install/secure the cooker hood.

Secure with 4 flange head screws

• Two people are needed to install/secure the cooker hood.

Extraction via exhaust ducting (vented outside)

• Ducting needs to be considered on top of the cabinet.

Tips for optimal air extraction

• Keep ductwork short and straight.
• Do not reduce the size or diameter of the duct.
• Keep ductwork taught to minimise pressure loss.

Extraction via recirculation (vented internally)

• Grille used from the separate ducting kit. Fitted to stop any debris from falling into the fan motor and causing damage.

CAUTION
A carbon filter must be fitted when venting internally,

Assemble a chimney to conceal the ducting

• Assembly a chimney depending on fittings available.

Decorative cover to conceal cooker hood, (optional)

Fit decorative panel, (optional)

• Secure the decorative panel depending on the fittings available
• The decorative panel must be removable for access to the cooker hood.

Install carbon filter – recirculation mode (vented internally)

• Carbon filters – supplied separately
• Carbon filters are only required when the appliance is installed in recirculation mode.
• Before attempting to install the carbon filter, ensure power to the cooker hood is switched off.
• Carbon filters have a limited life. We advise changing them when there is a noticeable drop in performance. The intervals between changing the filters will depend entirely upon the amount of cooking done, but on average a carbon filter will last 900 cooking hours – 3 to 5 years
• Replacement carbon filters may be purchased from your local Howdens depot or online. Part No: LAM2014

Install carbon filter

• Open the cover panel.
• Remove the grease filter(s).
• Install the carbon filter.
• Replace grease filters and close the cover panel.

Recirculation mode

• If the recirculation mode has been chosen, always set the recirculation programme on the cooker hood.

• Programme the carbon filter indicator;

• After installing a new carbon filter, programme the indicator.

• The cooker hood motor MUST be running.

• Press (2) and (3) at the same time for 3 seconds until the red LED flashes 3 times.

Electrical connections

Important: Ensure that the electricity supply is switched off before connecting.
When fitting in recirculation mode (with carbon filters), ensure the cable is shortened and securely held in place; or a cable grid is fitted to prevent the loose cable from falling back into the motor cavity.
Your appliance must be connected to fixed wiring via the use of a double pole switched fused spur outlet with at least 3mm contact separation, the isolation switch must be accessible after installation. (See technical data for fuse rating).

• The appliance should be connected by a suitably qualified person. The product must be installed under all local regulations.
• The terminology DOUBLE POLE -/+ means that both the live and neutral supplies are switched and disconnected at the same time.
• The terminations labelled SUPPLY are the connections for the internal house wiring.
• The terminations labelled LOAD are for connection to the appliance.

IMPORTANT: The wires in the mains lead are coloured under the following code:

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your spur box, proceed as follows;

• The blue wire must be connected to the terminal which is marked with the letter
• ‘N’ or coloured BLACK .
• The brown wire must be connected to the terminal which is marked with the letter
• ‘L’ or coloured RED .
• The green and yellow wire must be connected to the terminal which is marked with the letter
• ‘E’ or symbol.

Troubleshooting

What might be the cause of…?

Check that the grease filters and carbon filters (if vented internally) are fitted correctly.
Excessive noise: Airflow noises in the extractor ducting have a stronger impact on noise levels than the cooker hood itself. To help with this please ensure the following are checked.

• The hood has the correct size ducting.
• There are no restrictions within the ducting or outlet.
• The minimum number of 90-degree bends has been used.
• The hood has been secured to the wall correctly.
• The cable or any building material hasn’t been dropped into the fan area.
• In re-circulation mode, make sure the flue vents/grilles are not covered.
• For canopy cooker hoods, make sure there is a hole in the cabinet for the air to escape and that there is no shelf directly above the outlet.

Poor Extraction: The effectiveness of the cooker hood often comes from the relationship between the cooker hood and the exhaust duct components. To help with this, make sure all the following are checked.

• The hood has the correct size ducting.
• There are no restrictions within the ducting or outlet.
• The minimum number of 90-degree bends has been used.
• Ducting doesn’t exceed the recommended length run for the model installed.
• The hood should be switched on 10 minutes before and after cooking.

Technical Specification

TECHNICAL INFORMATION: The data plate on the side of the appliance states the total load when connected, the required voltage and frequency.

General
Total power consumption| 252 W
Fuse| 3 Amp
Voltage / Frequency| 220-240 V 50 Hz
Cable type / section| 3 core 0.75mm2
Cable length| 1.5 Metres
Lamps| 2 x 1.5 W LED 2700 K
Lighting efficiency class| A
Carbon filter| LAM2014

Where to find the model and serial number on the cooker hood. Inside the body of the cooker hood

Product information correct at the time of publication in March 2024. The company has a policy of continuous product development and reserves the right to change any products and specifications given in this manual. Subject to the Terms and Conditions of Trading, a copy of the Howdens Terms and Conditions is available upon request. Copyright © 2024 Howden Joinery Ltd. All rights reserved.

CONTACT

• Howden Joinery Ltd.
• Thorpe Road, Howden, East Yorkshire. DN14 7PA England Howdens Cuisines SAS. Z.A. du Bois Rigault Nord,
• 1 Rue Calmette, 62880 Vendin-le-Vieil, Cedex, France
• www.howdens.com
• www.howdens.com/appliance-registration

References

• Register an Appliance | Aftersales | Howdens
• Que Faire de mes Déchets ? Découvrez les solutions pour tous vos déchets et nos conseils pour en produire moins.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>