IKEA SALJEN Bath Faucet Black Instruction Manual
- June 1, 2024
- Ikea
Table of Contents
IKEA SALJEN Bath Faucet Black
Product Information
Specifications
- Pressure Range: 1 – 5 bar / 0.1 – 0.5 MPa / 14.5 – 72.5 psi
- Max Pressure: 0.5 – 10 bar / 0.05 – 1 MPa / 7.2 – 145 psi
- Thread Size: G1/2
- Max Installation Depth: 50mm
Product Usage Instructions
Installation
Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional.
Switching Mixer Tap
Before changing the mixer tap, switch off the main shut-off valve to prevent water flow.
Important Note
Do not tighten the components too hard during installation as this can damage hoses, pipes, and washers.
Frequently Asked Questions
- Q: What should I do if I am unsure about the installation process?
- A: If you have any doubts or uncertainties regarding the installation, it is recommended to seek assistance from a professional plumber or technician.
- Q: Can I install this product without following local regulations?
- A: It is crucial to adhere to the local construction and plumbing regulations during installation to ensure safety and compliance. Failure to do so may result in improper functioning or legal consequences.
- Q: How should I handle the product to avoid damaging hoses and pipes?
- A: When handling the product, especially during installation, avoid overtightening as it can lead to damage of hoses, pipes, and washers. Use the recommended torque levels provided in the manual.
Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional
- Switch off main shut-off valve before changing mixer tap.
Tools Required
Installation Instruction
IMPORTANT! Do not tighten too hard: this can damage hoses/ pipes and washers.
Before use:
Unscrew the Aerator/Flow Guide with a coin and allow the water to run freely
for a few minutes. Then screw the Aerator/Flow Guide back in place up to the
stop DO NOT OVER TIGHTEN
Check at regular intervals to make sure that the installation is not leaking
.