REMINGTON R4002 Style Series Rotary Shaver Instruction Manual
- June 1, 2024
- Remington
Table of Contents
REMINGTON R4002 Style Series Rotary Shaver
Specifications
-
Manufacturer: Spectrum Brands (UK) Limited
-
Address: Regent Mill, Fir Street, Failsworth,
Manchester M35 0HS -
Company Number: 02394603
-
Adapter Model Number: SW-047010UK
-
Input Voltage: 100 – 240 V~
-
Input AC Frequency: 50/60Hz
-
Output Voltage: 4.7 V
-
Output Current: 0.1 A
-
Output Power: 0.47 W
-
Average Active Efficiency: 40.4%
-
No Load Power Consumption: 0.1W
Getting Started
- Ensure the shaver is fully charged before initial use.
- Plug in the charger connector to the shaver and connect the adaptor to a power source.
- Allow for a complete charging cycle of 16 hours; the charging indicator light will turn off when charging is complete.
- The run time from a full charge is up to 40 minutes. It is recommended to completely drain the batteries every 6 months to preserve battery life.
Trimming
Follow these steps for trimming:
- Use the pivoting head and cutter assembly to adjust to the contours of your face for a close shave.
- Utilize the flexing heads for a comfortable shaving experience.
- To maintain precision, use the detail trimmer and adjust as needed with the trimmer release button.
- The hairpocket collects trimmed hair for easy disposal.
Care for Your Shaver
To ensure longevity and optimal performance of your shaver, follow these care
tips:
- Regularly clean the shaver using the provided cleaning brush.
- Avoid damaging the heads to prevent breakage.
- Refer to the manual for instructions on removing the rechargeable battery for maintenance purposes.
Frequently Asked Questions (FAQ)
Q: How often should I clean my shaver?
A: It is recommended to clean your shaver after each use to maintain hygiene
and performance.
Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.
-
Always check the appliance before you use it. Do not use the appliance if it is damaged, as this may cause injury.
-
The adaptor contains a transformer. Do not cut off the adaptor to replace it with another plug, as this causes a hazardous situation.
-
WARNING: Keep the appliance dry.
-
Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.
-
WARNING: For recharging the battery, only use the charger supplied with the appliance – type reference SW-047010UK.
-
Always replace a damaged adaptor with one of the original type.
-
Do not use the shaver, charging adaptor, charging stand or any other part if it is damaged, as this may cause injury.
-
This appliance should never be left unattended when plugged into a power outlet, except when charging.
-
Keep the power plug and cord away from heated surfaces.
Do not plug or unplug the appliance with wet hands. -
Do not twist or kink the cable, or wrap it round the appliance.
-
This appliance is not intended for commercial or salon use.
PARTS
- On/off switch
- Pivoting head and cutter assembly
- Flexing heads
- Hairpocket
- Detail trimmer
- Trimmer release button
- Charging indicator light
- Charger connector Not shown
- Adaptor
- Cleaning brush
- Stubble head guard
GETTING STARTED
CHARGING YOUR SHAVER
- It is recommended to fully charge your appliance before using it for the first time.
- Ensure the product is switched off.
- The adaptor automatically adjusts to a main voltage between 100V and 240V.
- Connect the shaver to the adaptor and then to the mains.
- The indicator light below the power switch will light up to indicate the shaver is charging.
- Charge time for the battery from empty to full charge is 16 hours. Remove from charging after 16 hours and the charging indicator will turn off.
- Run time from fully charged is up to 40 mins.
- Note: To preserve the life of your batteries, let them run out completely every 6 months and then fully charge.
- Do not recharge your shaver after each use as this will shorten the life of the battery.
INSTRUCTIONS FOR USE
SHAVING
- Switch the shaver on.
- Stretch the skin with your free hand so the hairs stand upright.
- Only apply light pressure on the shaving head while shaving (pressing too hard can damage the heads and make them vulnerable to breakage).
- Use short, circular strokes.
TRIMMING
- Slide the trimmer button to release the detail trimmer.
- Hold the trimmer at a right angle to your skin.
- Place the trimmer at desired trim line for a quick, easy, professional trim.
- To retract the trimmer, push down until it locks into position.
STUBBLE LOOK
- Fit the stubble head guard to your shaver for a 3-day stubble look.
TIPS FOR BEST RESULTS
- Always hold the shaver at right angles to the skin so that all three heads are touching the skin with equal pressure.
- Use moderate to slow stroking movements. The use of short circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
- DO NOT press hard against the skin in order to avoid damage to the rotary heads.
CARE FOR YOUR SHAVER
- Care for your appliance to ensure a long lasting performance. We recommend you clean your appliance after each use.
- Ensure the appliance is switched off and unplugged from the mains before cleaning.
- Open the shaver head by pressing the release button (Fig. A).
- Empty out any hair clippings.
- Pull the shaver head upwards to remove it from the body (Fig. B).
- Locate the centre arrow and slide the retainer in the opposite direction to release it. Once released, lift it out of the shaver head (Fig. C). Make a note of the correct orientation of the retainer to make refitting easier.
- Carefully brush away any hairs from the cutters.
- For a more thorough cleaning, lift out the three cutters (Fig. D).
- Wash the shaving head under running water (Fig. E). Allow to dry thoroughly.
- Carefully refit the three cutters.
- Refit the retainer. Locate the centre arrow and slide the retainer in the same direction as the arrow until it clicks into place (Fig. F).
- Once the shaver head is assembled, align the spring hinge with the slot at the back of the hair pocket and press into place (Fig. G). Snap the head assembly closed.
TRIMMER
Lubricate the teeth of the trimmer every six months with a drop of sewing
machine oil.
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery.
Parts of the shaver case, and tools have sharp edges and may cause injury if
not handled correctly.
- The rechargeable battery must be removed from the appliance before it is scrapped.
- Disconnect the charging adapter before removing the battery.
- Run the shaver until the motor stops.
- Unplug the shaver.
- Open the hair pocket and remove 1 screw from the top.
- Remove the three drive shafts and the shaver head
- Unscrew the 2 screws on the top housing.
- Carefully pry off the front housing.
- Unscrew the 6 screws on the inner housing.
- Carefully pry off the back housing.
- Lift the battery carrier and circuit board out of the shaver body then cut the tabs holding the batteries to the circuit board.
- Used batteries must be removed from the appliance and disposed of at an appropriate official recycling/collection point.
- Do not attempt to operate the shaver once you have opened it.
ADAPTER SPECIFICATIONS
RECYCLING
To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.
- 23/INT/ R4002 T22-7003093-B Version 12 /23
- Remington® is a Registered Trade Mark of Spectrum Brands,Inc., or one of its subsidiaries
- Russell Hobbs Deutschland GmbH, Am Unisyspark 1, 65843 Sulzbach, Germany remington-europe.com
- © 2023 Spectrum Brands, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>