IKEA STYRBAR Remote Control Kit User Manual
- May 15, 2024
- Ikea
Table of Contents
STYRBAR
For Apple devices, download the app using the App Store. For Android devices, download the app using Google Play store.
Note: If you have a TRÅDFRI gateway please use IKEA Home smart 1 app.
Getting started with DIRIGERA hub
Download the IKEA Home smart app and follow the instructions on screen to add
the product to your IKEA Home smart system.
Remote control functions
Short press to turn on. To dim up, press and hold the button.
Short press to turn off. To dim down, press and hold the button.
Change white spectrum or colours .
Pairing: Add IKEA Smart Lighting products to your system. See instructions
below.
Adding devices to your remote control
When the remote control is sold together with a light source (in the same
package), they are already paired. If the remote control is purchased
separately, you must manually pair it to your light source.
To add light sources, just repeat the steps below.
- Make sure that your light source is installed and the main power switch is turned on.
- Hold the remote control close to the light source you want to add (no more than 5 cm away).
- Press the pairing button 4 times within 5 seconds. A red light will shine steadily on the remote control.
Your light source will begin to dim and flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 remote control. Make sure to pair
them one at a time. If the light sources are close to each other, disconnect
those that have already been paired from the main power switch.
Factory reset your devices For light sources:
Toggle the main switch 6 times.
For remote control:
Press the pairing button 4 times within 5 seconds.
Synchronizing
If your light source becomes unsynchronized, a long press on the left (<) or
right (>) buttons will return the light source to its default setting (2700K).
Changing the battery
When the remote control is used regularly and as intended, the batteries will
last for approximately 2 years.
When it’s time to replace the battery, a red LED indicator will flash when you
press any button on the remote control. Open the battery lid and replace the
battery with two new AAA/HR03 batteries.
Caution!
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Important!
- The remote control is for indoor use only and can be used in temperatures ranging from 0ºC to 40 ºC (32ºF to 104ºF).
- Do not leave the remote control in direct sunlight or near any heat source, as it may overheat.
- The range between the remote control and the receiver are measured in open air.
- Different building materials and placement of the units can affect the wireless connectivity range.
Care instructions
To clean the remote control, wipe with a soft cloth moistened with a little mild detergent. Use another soft, dry cloth to wipe dry.
Note!
Never use abrasive cleaners or chemical solvents as this can damage the
product.
Recommended battery types:
2 x IKEA LADDA 900 (AAA/HR03, 1.2V, 900mAh, Ni-MH) (Not included)
Do not mix batteries of different capacities, types or date stamps.
TECHNICAL DATA
Type: E2001
Name:
STYRBAR Remote control stainless
Type: E2002
Name: STYRBAR Remote control white
Input: 3V, 2x AAA/HR03 LADDA batteries
Range: 10 m in open air.
For indoor use only
Operating frequency : 2405-2480 MHz
Output power: 12.6 dBm (EIRP)
IP-class: IP44
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN
This device complies with Part 15 of the FCC Rules/Innovation Science and
Economic Development Canada’s licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the quipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE INFORMATION
This product is approved as a portable handheld device (not body worn) This
product includes a static magnet, generating a magnetic field that might
interfere with the normal operation of pacemakers, defibrillators, or other
medical devices.
Maintain a safe distance of separation between your medical device and this
device. Stop using this device and consult your physician or medical device
manufacturer if you believe that it is interfering with your medical device.
License rights and limitations
NO RIGHTS OR LICENSES, EXPRESS NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE
GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A
WIRELESS MESH NETWORK, OR TO USE THIRDPARTY
SERVICES TO ACCESS, MONITOR OR CONTROL THESE PRODUCTS IN A WIRELESS MESH
NEWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK.
For use pursuant to U.S. Patent Nos.:
US 6,914,893
US 7,697,492
US 8,964,708
**** The crossed-out wheeled bin symbol indicates that the item should be
disposed of separately from household waste. The item should be handed in for
recycling in accordance with local environmental regulations for waste
disposal. By separating a marked
item from household waste, you will help reduce the volume of waste sent to
incinerators or land-fill and minimize any potential negative impact on human
health and the environment. For more information, please contact your IKEA
store.
MX
Importador/Distribuidor: IKEA Supply
Mexico, S.A. de C.V., Calle Oriente 158, número 440, Piso 3, Local JD-01,
Colonia Moctezuma, Segunda Sección,
Alcaldía Venustiano Carranza, C.P.
15530, Ciudad de México.
Tel. 55-8310-8310.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>