COMDRONIC AC7-HP+ High Pressure Water Manometer User Guide
- May 15, 2024
- COMDRONIC
Table of Contents
COMDRONIC AC7-HP+ High Pressure Water Manometer User Guide
PRODUCT OVERVIEW
PROTECT FROM FROST IN STORAGE
TOTAL SYSTEM PRESSURE = 20 BAR MAX.
-
Connect the RED connection tube to this connector.
Internal strainers protect the sensor-unit from small dirt particles.
These are service parts.
Note: blocked strainers will slow performance and reduce accuracy. -
Equalising valve.
-
Press to access the handset’s on-board valve database.
-
Press to cancel an entry or to return to a previous screen. Also use to switch the AC7 ‘OFF’.
-
Connect the BLUE connection tube to this connector.
-
Securing ring. Use the lanyard supplied to suspend the AC7 from pipework (or similar) while taking readings.
-
Press to set a zero datum before taking a measurement.
-
Use ▲ ► ▼ ◄buttons for menu navigation and to enter numerical data – see note below.
-
Press to toggle between available display screens. Also use to accept menu selections and screen entries.
-
Press to enter menu screens.
Numeric entries: use the ▲ ▼ buttons to increase or decrease values. Use the ► button to add a digit. If a decimal point is required, press the ▼ button when the zero digit is showing. To enter a negative number, press the ZERO button before any number is added.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>