cantaloupe G Series High Gain Antenna Instruction Manual
- June 12, 2024
- cantaloupe
Table of Contents
cantaloupe G Series High Gain Antenna
Product Information
The product is a high-gain antenna designed to enhance the performance of a card reader. It is intended to be installed in a location near the card reader but away from electronic devices such as fluorescent lights, motors, and transformers. The antenna comes with a cable and an antenna base with a rubber gasket for installation.
Tools Required
- Drill
- 7/16 auger bit
Product Usage Instructions
- Choose a suitable location near the card reader, ensuring it is away from electronic devices.
- Using a drill and a 7/16 auger bit, create a hole from the top of the door or frame.
- Insert the cable and the antenna base with the rubber gasket into the hole from the top. Place the star washer on the base, and tighten the nut until the star washer firmly contacts the metal casing for grounding.
- Thread the cable through the rubber grommet and hole, then attach it to the back of the card reader. It is important not to bundle or coil the cable.
- Tape or tie down the cable to prevent it from being pinched or crimped by the door.
To access an online version of these instructions, you can scan the QR code provided in the manual. If you need further assistance, you can contact our customer service:
- Phone: +1 888.561.4748
- Email: [email protected]
Tools Required
- Power drill
- Metal auger drill bit with a 7/16″ setting
- Slip-joint pliers
- Tape or tie-wraps for the cable
Installation Instructions
- Place the antenna in a location near the card reader but away from electronic devices, including fluorescent lights, motors, and transformers.
- Drill a 7/16″ hole with an auger bit from the top of the door or frame.
- Place the cable and the antenna base with the rubber gasket into the hole from the top. Place the star washer on the base, and tighten the nut until the star washer firmly contacts the metal casing for grounding.
- Thread it through the rubber grommet and hole, then attach it to the back of the card reader. DO NOT BUNDLE OR COIL THE CABLE.
- Tape or tie down the cable so that the door does not pinch or crimp it.
- To access an online version of these instructions, scan the QR code.
Need some help?
- Phone: +1 888.561.4748
- Email: [email protected].
Read User Manual Online (PDF format)
Loading......