MUSCLED MT-MFTR MD Muscle Flight Trainer Instruction Manual
- June 1, 2024
- MUSCLED
Table of Contents
MUSCLED MT-MFTR MD Muscle Flight Trainer Instruction Manual
MT-MFTR
Step 1
Push the foot platform into the base of the main unit and secure with the 4
Hex screws (#6), washers (#7), and Locknuts (#8)…see the diagram below.
Step 2
Attach (screw in) the 6 rubber feet to the underside of the main frame and
platform(3 on each side)…easy just to tip the one side forward to gain access
to the underside of the frame…repeat on the other side. These feet can be
adjusted in and out to level the machine more in and out as all floors are not
level.
Step 3
Attach 2 arms to cams on the front of the machine.
Step 4
Loosen the guide rods by unscrewing the 2 metal caps on top of the frame…Note
that there is a split ring collar on the top of each guide rod on each
aluminum retainer.
Step 5
Lift off the top plate and cable attached assembly.
Step 6
Feed the selector plates onto the guide rod making sure that the openings for
each plate are facing forward so that the selector pin can slide into each
plate.
Step 7
Replace the top plate onto the guide rods being careful not to tangle the
cables.
Step 8
Screws each guide rod into the aluminum retainer and reposition the split ring
collars into the groove of each retainer.
Step 9
Slide Frame Caps (#3) onto the top of the machine above the guide rods…and
line up the holes with the proper mounts welded to the frame. Note the you
might have to gently pull and open the Frame Cap to fit it onto the frame.
Step 10
Use 4 Hexagon Socket Head screws(#5) to attach Frame cap to the Main frame.
Step 11
Loosen the 3 screws on each inside of the frame slightly then place the Frame
Cover (#4) onto each screws…then tighten the screws. Note that the weight
stack is in the way of tightening the lower screw on each side of the frame.
So use one of the arms to raise the weight stack so that it clears the way to
tighten the lower screw on each side of the frame.
Step 12
Slide Frame Caps (#3) onto the top of the machine above the guide rods…and
line up the holes with the proper mounts welded to the frame. Note the you
might have to gently pull and open the Frame Cap to fit it onto the frame.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>