TAC 215030 Side Steps Running Boards Instruction Manual
- June 1, 2024
- TAC
Table of Contents
TAC 215030 Side Steps Running Boards
Specifications
- Product Name: TAC Side Steps Running Boards
- Compatibility: 2021-2024 Ford Bronco 2 Door SUV
- Color: Black
- Material: Steel
FAQ
Frequently Asked Questions
- Q: Can these Side Steps be installed on other vehicle models?
- A: These Side Steps are specifically designed for the 2021-2024 Ford Bronco 2 Door SUV and may not be compatible with other models.
- Q: How should I maintain the Side Steps for long-lasting durability?
- A: Regularly clean the Side Steps with mild soap and avoid using abrasive polishes or waxes. Inspect the mounting hardware periodically for tightness.
Side Steps
- TAC Side Steps Running Boards Compatible with 2021-2024 Ford Bronco 2
- Door SUV 3″ Black Side Bars Step Rails Nerf Bars Off Road Accessories (2 pcs Running Boards)
- PART#: 215030
PARTS LIST
| 1 | Driver/Left 3inch Sidebar | 8 | 10mm x 30mm Hex Bolts |
|---|---|---|---|
| 1 | Passenger/Right 3inch Sidebar | 8 | 10mm Lock Washers |
| 2 | Front Mounting Brackets | 8 | 10mm x 27mm OD x 3mm Flat Washers |
| 2 | Rear Mounting Brackets | 8 | 8mm x 25mm Combo Bolts |
Installation Instructions
PROCEDURE:
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
- Starting from underneath the Passenger/Right body panel, locate the front mounting location and the threaded holes in the body panel, (Figure 1). Remove the plastic plugs covering the holes.
- Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket to the front location with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Figure 2). Do not tighten hardware.
- Repeat Steps 2 & 4 to attach (1) Rear Mounting Bracket to the rear location, (Figures 3 & 4). Do not tighten hardware.
- Select the Passenger/Right Sidebar. Place the Sidebar onto the cradles of the Mounting Brackets.
- IMPORTANT: Do not rotate or slide the Sidebar front to back or damage to the finish may result. Attach the Sidebar to the Mounting Brackets with (4) 8mm Combo Bolts, (Figure 5). Do not tighten hardware.
- Level and adjust the Sidebar and tighten all hardware.
- Repeat Steps 1—7 to attach the Driver/Left Sidebar.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Sidebars.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>