TAC SW-C06 Sidewinder Running Boards Instruction Manual
- June 1, 2024
- TAC
Table of Contents
TAC SW-C06 Sidewinder Running Boards
Torque & Tools
-
60-120 min
-
Cutting Not Required
-
Drilling Not Required
Fastener Size| Tightening Torque (ftlbs)| Wrench Required|
Allen Wrench Required
---|---|---|---
□ 6mm| □ 7-8.5| | □ 10mm| | □ 4mm
■ 8mm| ■ 18-20| ■ 13mm| □ 5mm
□10mm| □ 35-40| □ 16mm| □ 6mm
□12mm| □ 60-70| □ 18mm| □ 8mm
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
ASSISTANCE IS RECOMMENDED.
Part List
-
8mm x 30mm Hex Bolt
-
8mm Flat Washer
-
8mm Lock Washer
-
8mm x 25mm Combo Bolt
INSTALLATION INSTRUCTIONS
PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE PASSENGER SIDE INSTALLATION
STEP 1
Start the installation under the Passenger/Right side of the vehicle. Locate the 8 plugs along the bottom edge of the body. Remove the plastic plugs from each mounting location, (Fig 1).
Fig 1) Remove plastic plugs (arrows) to uncover threaded holes in floor
STEP 2
Mounting Brackets will attach to all threaded mounting holes, (Fig 2). Directly above each threaded hole is a top mounting location on the side of the body panel. Hold a Bracket up in place to help determine the mounting holes to use along the body. NOTE: Thread an 8mm Hex Bolt into the threaded holes to clear paint as required.
(Fig 2) Threaded holes (arrows) under the plastic plugs
STEP 3
Select (1) Passenger/Right Mounting Bracket. Attach the Mounting Bracket to the factory threaded holes with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Fig 3). Do not tighten hardware.
(Fig 3) Attach (1) Mounting Bracket to the Passenger/Right front location
STEP 4
Move along the body to the next mounting location. Repeat Steps 1 – 3 to attach the remaining (3) Passenger/Right Mounting Bracket to the (3) remaining locations.
STEP 5
Select the Passenger/Right Running Board.
NOTE: The Passenger/Right Running Board will have a “06-R” on the front.
Place the Running Board onto the Mounting Brackets. IMPORTANT: Do not slide
the Running Board front to back or damage to the finish may result. Attach the
Running Board to the Mounting Brackets with (8) 8mm Combo Bolts, (Fig 4).
(Fig 4) Attach the Passenger/Right Running Board to the Mounting Brackets
STEP 6
Level and adjust the Running Board and fully tighten all hardware.
STEP 7
Repeat Steps 1—6 to attach the Driver/Left Running Board.
STEP 8
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may
contain abrasives that could damage the finish.
Mild soap may be used also to clean the Running Boards.
CUSTOMERS SUPPORT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>