Motack HSW-B6A Rotatable Bicycle Phone Holder User Manual

Motack HSW-B6A Rotatable Bicycle Phone Holder

360° Rotatable Bicycle Phone Holder

Part Name

1. Security Lock
2. Fixed Slot
3. Rotating Part
4. Swivel Bolt
5. Socket
6. Nut
7. Fixing Clamp
8. Silicone Pad
9. Lock Screw
10. Lower Arm
11. UpperArm

INSTALLATION

• Loosen the fixing clamp and install it to the handlebar
  Note : Please add or remove the silicone pads according to the diameter of the handlebars, which also can cut unnecessary parts.

• 3. Insert the rotating part of the base into the fixed slot on the back along the direction shown in the picture below.

• 4. Unlock the security lock on the back of the phone holder, push the upper arm of the phone holder with the top of the phone, and then put the phone in.

• 5. After the phone is fixed, pull the security lock on the back to the locked state.

Warm Tips

1. This bike phone holder can only support phones up to 15mm thick (including the phone case).
2. Please make sure the security lock is locked after you set your phone in the holder.

For Smartphones 4.7″-6.8″
For Handlebars 1.5CM-3.5CM(0.59″-1.38″)

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>