TAC SW-C07 Sidewinder Running Boards Installation Guide
- June 1, 2024
- TAC
Table of Contents
SIDEWINDERRUNNINGBOARD
PART#:SW-C07
FITS:
2019-Up Chevy Silverado 1500 Regular Cab
2020-Up Chevy Silverado 2500-3500 Regular Cab
2019-Up GMC Sierra 1500 Regular Cab
2020-Up GMC Sierra 2500-3500 Regular Cab
Torque & Tools
| |
---|---|---
60-120 min| Cutting Not Required| Drilling Not Required
Fastener Size| Tightening Torque (ft-lbs)| Wrench Required|
Allen Wrench Required
---|---|---|---
□ 6mm| □ 7-8.5| 
| □ 10mm| | □ 4mm
■ 8mm| ■ 18-20| ■ 13mm| □ 5mm
□ 10mm| □ 35-40| □ 16mm| □ 6mm
□ 12mm| □ 60-70| □ 18mm| □ 8mm
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
ASSISTANCE IS RECOMMENDED.
Part List
PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE PASSENGER SIDE
INSTALLATION
STEP 1
Start the installation under the Passenger/Right side of the vehicle. Locate
the 4 plugs along the bottom edge of the body. Remove the plastic plugs from
each mounting location, (Fig 1).
STEP 2
Mounting Brackets will attach to all threaded mounting holes, (Fig 2).
Directly above each threaded hole is a top mounting location on the side of
the body panel. Hold a Bracket up in place to help determine the mounting
holes to use along the body.
NOTE: Thread an 8mm Hex Bolt into the threaded holes to clear paint as
required.
STEP 3
Select (1) Passenger/Right Mounting Bracket.
Attach the Mounting Bracket to the factory threaded holes with (2) 8mm Hex
Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Fig 3). Do not tighten
hardware.
STEP 4
Move along the body to the next mounting location. Repeat Steps 1 – 3 to
attach the remaining (1) Passenger/Right Mounting Bracket to the remaining
rear locations.
STEP 5
Select the Passenger/Right Running Board.
NOTE: The Passenger/Right Running Board will have a “07-R” on the front.
Place the Running Board onto the Mounting Brackets.
IMPORTANT: Do not slide the Running Board front to back or damage to the
finish may result. Attach the Running Board to the Mounting Brackets with (4)
8mm Combo Bolts, (Fig 4).
STEP 6
Level and adjust the Running Board and fully tighten all hardware.
STEP 7
Repeat Steps 1—6 to attach the Driver/Left Running Board.
STEP 8
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may
contain abrasives that could damage the finish.
Mild soap may be used also to clean the Running Boards.
www.tacautoparts.com
Customer Support:tac-office@tacautoparts.com
Rev. 8/23/22 (NL)
Documents / Resources
| TAC
SW-C07 Sidewinder Running
Boards
[pdf] Installation Guide
SW-C07, SW-C07 Sidewinder Running Boards, Sidewinder Running Boards, Running
Boards, Boards
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>