TAC 4S-F1122-1N Arrow Side Steps Instruction Manual

Table of Contents

Product: 4-Inch Oval Straight Sidebars
Vehicle Compatibility: 2015-2023 F150 Supercrew Cab, 2022-2023 F150 Lightning EV Supercrew Cab, 2017-2023 F250/350/450/550 Super Duty Crew Cab
Part Number: 4S-F1122-1N

Parts List:

Remove all contents from the box and verify all parts are present.
Start the installation under the Driver/Left side of the vehicle. Prepare the factory mounting locations.
Attach plastic washers to the factory mounting studs to prevent corrosion.
Attach support brackets and front mounting brackets to the designated locations without tightening the hardware.
Repeat steps to attach center/rear mounting brackets and support brackets.
Attach the Driver/Left Sidebar to the mounting brackets without tightening the hardware.
Level and adjust the Sidebar before tightening all hardware.
Repeat the process for the Passenger/Right Sidebar.
Perform periodic inspections to ensure all hardware remains secure and tight.

Cleaning Instructions
To protect your investment, do not use polish or wax containing abrasives. Clean the Sidebar with mild soap only.

Can I install these sidebars alone?
While installation assistance is recommended, it is possible to install the sidebars alone following the provided instructions carefully.
How do I know if all parts are present in the package?
Before starting the installation, make sure to check against the parts list provided in the manual to ensure all components are included.

1	Driver/Left Sidebar	12	8mm x 25mm Combo Bolts
1	Passenger/Right	24	8mm x 24mm OD x 2mm Flat Washers
2	Front Mounting Brackets	24	8mm Nylon Lock Nuts
4	Center/Rear Mounting Brackets	18	8mm Plastic Retainers
6	Support Brackets

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED.

Start the installation under the Driver/Left side of the vehicle. Locate the front factory mounting location along the inner side of the body, (Figure 1). Use a wire brush or thread chaser die to remove excess paint and/or undercoating from all studs.
Slide (1) Plastic Washer over each of the (3) factory mounting studs in the body panel, (Figures 2—3). IMPORTANT : The Plastic Washers are designed to prevent corrosion between the aluminum body panel and the steel mounting brackets. Do not install the Brackets without the Plastic Washers.
Select (1) Support Bracket, (Figure 4). Attach the Bracket to the (2) studs on the pinch trim with (2) 8mm Flat Washers and (2) 8mm Nylon Lock Nuts, (Figures 4 & 5). Do not tighten hardware.
Select (1) Front Mounting Bracket, (Figure 6). Attach the Bracket to the upper stud in the rocker panel and Support Bracket with (2) 8mm Flat Washers, and (2) 8mm Nylon Lock Nuts, (Figure 6). Do not tighten hardware.
Repeat Steps 3 & 4 to attach (2) Center/Rear Mounting Brackets and (2) Support Brackets to the center and rear mounting location.
Select the Driver/Left Sidebar. Attach the Sidebar to the (3) Mounting Brackets with (6) 8mm Combo Bolts, (Figure 7). Do not tighten hardware.
Level and adjust the Sidebar, then tighten all hardware.
Repeat Steps 1—7 to attach the Passenger/Right Sidebar.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.