TAC 40-23700TN Side Steps Running Boards Installation Guide
- June 1, 2024
- TAC
Table of Contents
TAC 40-23700TN Side Steps Running Boards
PARTS LIST:
| 1 | Driver/Left side PNC Sidebar | 12 | 8mm x 25mm Combo Hex Bolts |
|---|---|---|---|
| 1 | Passenger/Right side PNC Sidebar | 8 | 8mm x 25mm Hex Bolts |
| 4 | Front/Rear upper support brackets | 20 | 8mm x 24mm OD x 2mm Flat Washers |
| 4 | Front/Rear lower mounting brackets | 16 | 8mm x 16mm OD x 1.6mm Flat Washers |
| 2 | Center Mounting Brackets | 28 | 8mm Nylon Lock Nuts |
| 2 | Support Brackets |
PROCEDURE
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. USE WIRE BRUSH TO CLEAN MOUNTING STUDS OF PAINT AND DEBRIS.
- Start the installation under the Driver side of the vehicle. Locate the front (3) factory studs along the inner side of the body panel, (Figure 1).
- Select (1) Front/Rear upper support bracket. Attach the Mounting Bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts, (Figure 2). Leave hardware loose at this time.
- Next, attach (1) Front/Rear upper support bracket to the welded plate on the back of the Front/Rear lower mounting Bracket with (2) 8mm Nylon Lock Nuts, (4) 8mm Flat Washer, and (2) 8mm Hex Bolts, (Figure 3).
- Locate the center (3) factory studs along the inner side of the body panel, (Figure 4).
- Select (1) Support Bracket. Attach the Support Bracket to the (2) factory studs with (2) 8mm Flat Washers and (2) 8mm Nylon Lock Nuts, (Figure 5).
- Then attach (1) Center Mounting Bracket to the upper factory mounting stud and support bracket with (2) 8mm Flat Washers and (2) 8mm Nylon Lock Nuts, (Figure 6).
- Repeat Steps 2—4 to attach the remaining (1) Front/Rear upper support bracket and (1) Front/Rear lower mounting bracket to the rear mounting locations along the body panel, (Figures 7).
- Attach the (1) Driver/Left side PNC Sidebar to the (3) Mounting Brackets with (6) 8mm Combo Hex Bolts, (Figure 8). Do not tighten hardware.
- Level and adjust the Side Bar as necessary and fully tighten all hardware.
- Repeat Steps 1—10 to attach the Passenger/Right side PNC Sidebar to the vehicle.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment ; Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Side Bar.
Driver/Left Side Installation Pictured
CUSTOMER SUPPORT
www.tacautoparts.com
of 3 7/27/22 (CC)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>